glanza engine into ep82

[ralphie_EP82]

might seem like a silly question but is it harder at all to put a 4efte from a glanza into my ep82? thanks Ryan

 

[fishman]

New to this, but shoot me if I'm wrong but I think only difference are the rods between the two engines? I'm guessing it goes straight in man

 

[turboloon]

is this engine from andy i from elgin..?get a td04 in there as well ralphie,you won't regret it min...

 

[ralphie_EP82]

is this engine from andy i from elgin..?get a td04 in there as well ralphie,you won't regret it min...

is that the guy thats sellin the full td04 kit for 1000? i never realised there was an engine for sale in elgin too will you post link for me m8?

 

[Jay]

A few sensors need swapped across from your old engine by otherwise it's a straight swap. Internals differ too but it shouldn't be an issue.

Jay

 

[ralphie_EP82]

A few sensors need swapped across from your old engine by otherwise it's a straight swap. Internals differ too but it shouldn't be an issue.

Jay

ok thanks thats about a clear cut as i could have asked for

 

[peter88]

I'm putting a gt engine in my glanza is there any sensors that need swapped over on that?

Sorry for interrupting ur post

 

[ralphie_EP82]

I'm putting a gt engine in my glanza is there any sensors that need swapped over on that?

Sorry for interrupting ur post

no problem i already found out what i need, but im guessing it would be visa versa on the sensors?

 

[peter88]

yea i suppose so

 

[Jay]

You guessed it mate, one of the temp switches and the inlet temp sensor need swapped (from memory) but if you have your old engine it's a straight swap.

Jay

 

[Paddy]

i put a gt engine in my glanza, i put the inlet manifold with all sensors from glanza engine to the gt one and it was fine

 

[peter88]

Cool I think I'm swapping my inlet too, was that all you needed to swap then?