Starlet Nath
Member +
Hello peeps,
I am just about to start to strip my 4e, I'll be using Pauter rods, 74.5mm ross flat top pistons, redrill and tap block for ARP head studs when I rebuild. I will be using a Sard K26 kit, however I am unsure what head gasket size to go for.
I know because my pistons are flat topped, and my head will have had a light skim off it that the C/R will be higher. So do I go for 1.4mm? As I intend to evenutally run high boost with the K26.
Any advice would be appreciated,
Cheers
Nath
I am just about to start to strip my 4e, I'll be using Pauter rods, 74.5mm ross flat top pistons, redrill and tap block for ARP head studs when I rebuild. I will be using a Sard K26 kit, however I am unsure what head gasket size to go for.
I know because my pistons are flat topped, and my head will have had a light skim off it that the C/R will be higher. So do I go for 1.4mm? As I intend to evenutally run high boost with the K26.
Any advice would be appreciated,
Cheers
Nath