hole type hks actuator???

P

peter88

Member +
anyone heard of it, a guy on the wanted section said he had one but never fitted it so did not know if it fitted a glanza?

cheers
 
P

peter88

Member +
my turbo isnt fitted yet so might be a bit easier to fit, what is the difference between a hole type and a normal one do you know, thanks?
 
pig666eon

pig666eon

Member +
peter88 said:
my turbo isnt fitted yet so might be a bit easier to fit, what is the difference between a hole type and a normal one do you know, thanks?
Click to expand...

well the hole type basically has a hole and you need to get some sort of locking nut to go through the wastegate arm and into the actuator arm

the clip type is the same setup as the standard actuator the arm has a little piece attached that fits through the wastegate arm and a clip then locks it in place

its not hard to mount the actuator but for the hole type finding the right screw and lock nuts is the hard part
 
P

peter88

Member +
pig666eon said:
well the hole type basically has a hole and you need to get some sort of locking nut to go through the wastegate arm and into the actuator arm

the clip type is the same setup as the standard actuator the arm has a little piece attached that fits through the wastegate arm and a clip then locks it in place

its not hard to mount the actuator but for the hole type finding the right screw and lock nuts is the hard part
Click to expand...


Ah great mate thanks for the info, repd
 
Spoonz

Spoonz

Member +
a hole type is for the older gt's where the pin is on the wastegate arm and the pin type is for the newer type where the wastegate arm has the hole
 
J25GTi

J25GTi

Lifer
Hole type is always better anyway, use an m4 bolt, nut and washers, the other type is a pin type and uses a crappy c clip that is a royal pain in the ass to get on and off and your garunteed to lose it!
 
You must log in or register to reply here.
Top