how to wire an emanage ultimate for an ep82

williamocarroll1982

williamocarroll1982

Member +
Sparky said:
I can do that for you pal, are you looking at the connector with the clip at the top or bottom just so we dont get our wires crossed, excuse the pun :p
Click to expand...

Im looking at the connector with the clip at the top. I am also looking at the connector as the wires go into it, not the side that plugs into the emu if you get me

IMG_0171_1__1_.jpg
 
Last edited:
S

Sparky

Member +
14 pin connector (Connector C)

Viewed from left to right
Last pin on the top row- Yellow/grey stripe
Last pin on the bottom row- Light blue/brown stripe
(Also, are these wires connected to the Factory contorlled boost cut or fuel cut wire)- cant answer this sorry mate

4th pin on the bottom row- Brown/yellow stripe
5th pin on the bottom row- Light blue/yellow stripe



Hope this helps you :)
 
williamocarroll1982

williamocarroll1982

Member +
Sparky said:
14 pin connector (Connector C)

Viewed from left to right
Last pin on the top row- Yellow/grey stripe
Last pin on the bottom row- Light blue/brown stripe
(Also, are these wires connected to the Factory contorlled boost cut or fuel cut wire)- cant answer this sorry mate

4th pin on the bottom row- Brown/yellow stripe
5th pin on the bottom row- Light blue/yellow stripe



Hope this helps you :)
Click to expand...

Is yours wired into a patch loom or is it not fitted to your car yet? If its fitted to a patch loom you could tell me what wire those two wires are wired into and I could use that
 
S

Sparky

Member +
I have a word document of the EMB wire colour codes.

Just post it as an attachment. I did the same with the EMB doc earlier on the emanageforum :)
 
S

Sparky

Member +
hmmmm is says at the bottom in the posting permission box that I dont have permission to post attachments? :confused: :haha:
 
S

Sparky

Member +
Thats pretty awesome mate repped :)

Only checked the EP82 one.

Exactly what us EMU users need though :)

This should be sticky'ed
 
C

chinesemafia

Member +
hey sparky did you ever get ur emu running via the info hosted here ??

reason i asked is cause i have a few concerns as im now trying to put my EMU in my ep82

first of all acording to the document on here the brown emu wire(RPM) should be tapped to connect 1 pin 7 on the ecu
now looking at the ecu pin out it says that pin 7 on connector 1 is ignition feed back from coil
how ever pin 21 on connecter 1 is labled RPM
so is the document correct or should this be changed ???

secound the document indicated that the analog out put wire for the emu is light blue brown . looking at my emu harness there is no such wire combo nor is this combo listed in the emu manual

analog imput is also as per the document yellow grey how ever according the emu manual that color combo is for the injector output signal ch3

there for analog input should be white green

and anlog output should be green grey

correct me if im wrong guys dont wana damage my emu or my ecu thanks

also could some one please conferm if this input and out put got to the fuel cut wire (pin 4 connector 2) or boost controller wire (pin 15 connetor 2)
the document idicates that the auther was not sure

third the emu grey white (crank angle signal input )accourding to the document goes to connector 1 pin 21 (intergrated ignition assembly (rpm)) yet pin 9 on connector 1 is labled distributer crank angle



could some of you guys who have done it right befor please help

thanks
 
You must log in or register to reply here.
Top