yes i can workout a small discount for you guys. but it wont be anything great guys as we keep out profit margins as low as possible to make our products very affordable for you guys. so i sincerely hope you understand.
dave, you dont need any other mods. well you have to buy yourself a tial 38mm wastagete..but thats about it. the kit comes with the manifold/de-cat and oil feed. so you cannot stock stock cat/downpipe. you have to use the one supplied with the kit.hope this clears up Q's you have. you are more than welcome to u2u me if you have any further querries...thanks
Just one more quick question looking at the pictures of the kit. Will the standard EFI intake pipe fit with the wastegate bolted on as it does not look like it will run over the top.
Just one more quick question looking at the pictures of the kit. Will the standard EFI intake pipe fit with the wastegate bolted on as it does not look like it will run over the top.
i have a WEPR CT9 power up kit and turned/clocked the turbo an a WEPR FMIC, so needless to had to cut and shut the IC pipes a lot!!
You able to sell just the clocked turbo - Intercooler pipe?
Is it a 1 piece pipe? I can see a problem if it wrong angle slightly, as where i still have AC its a nightmare to have a clocked turbo! (had to cut off the lugs on compressor wheel!! (for the actuator)
Where i have clocked it to is the only place possible tbh mate, while giving maximum (like 20-30mm!!!!) clearance to the rad!!!
Thats cool sounds like the best thing for me, just worried it might not go, but i can always get a disc cutter out and bend the pipe and reweld if angle slightly off!!!
Once i get paid (like should be anythime now being end of month) i will have the pipe off ya mate. Do you accept paypal now or still gotta be bank transfer? Hope my stupid bank dont screw it up again!!"