progressive TPS on manual ECU

azerty

Supermoderator
Hello,

I would like to know if a progressive TPS would work on a manual gearbox ECU (GT or glanza) if so, how to plug it, as there are 4 wires instead of 3.
 

D3N0

Member +
Hello,

I would like to know if a progressive TPS would work on a manual gearbox ECU (GT or glanza) if so, how to plug it, as there are 4 wires instead of 3.
Only if used with an aftermarket ecu that can pick up the signal. fitting it would depend what management you have.
 

Sagittarius

Member +
azery, do you mean the 4-wire automatic tps? it will work on a manual ecu, but don't expect to pass emissions ay your car will run too rich.
 

weeJohn

Lifer
Hello,

I would like to know if a progressive TPS would work on a manual gearbox ECU (GT or glanza) if so, how to plug it, as there are 4 wires instead of 3.

It wont work well, as the lad above said it will run rich at idle and never see WOT.

The car will run but, put a multimeter over the wires, 2 are low resistance and connect them to the bottom 2 wires of the manual tps plug.
 

azerty

Supermoderator
So I guess the progressive TPS isn't moving from 5 volt to Zero. better use ON/OFF 3 wires TPS then...
thanks guys.

Sagittarius, is there any parameters you can change in the 4efte PFC ? if not, I'm afraid you'll have to keep standard TPS then
 
Last edited:

Sagittarius

Member +
well, if you also have the auto ecu you can do your tuning on the amount of therottle you give to your car. You can finetune your fuelling better than with the 3 wire tps.
 
Top