rear bearing failure. i need help

[HiGGYep91]

the nut which holds the disc on melted to the bearing and then it rung so had to go to extreme measures to get it off

disc had to be chopped in order to get in at the nut

a good disc compared to what i had to do to the old one

can the shaft the wheel bearing sits on be replaced or will i need a whole new axle??

any help much appreciated

 

[Jay]

A fresh rear axle is your best bet mate, even one from a non-turbo can be used if you are stuck. One thing to bear in mind is the EP91 version is around 10mm longer than the EP82 unit but it shouldn't make much difference.

Jay

 

[ChrisStarletGT]

they bolt on the four bolts u see in pic i think so u should be able to get another from a breaker

 

[HiGGYep91]

those 4 bolts only hold on the dust sheild and brake caliper bracket

 

[ChrisStarletGT]

oreet hav u taken them off to check

 

[HiGGYep91]

ya. a member on a different site told me the stub bolts off but it doesnt. its welded on

 

[WallaceGlanza]

ya. a member on a different site told me the stub bolts off but it doesnt. its welded on

I can confirm this, have mine completely apart at the moment.

 

[ChrisStarletGT]

new rear axle then aint it m8