Starting from scratch!!

glanzanut

glanzanut

Lifer
depends what setup ur lookin for bud. 1bar ct9 u need fpr, fcd, uprated suspension and brakes. adjustable actuator. if u do a search there is plenty of detailed info
 
Aidan@EP-styling

Aidan@EP-styling

Trader
if its completely stock then this is the order in which I would do things

- boost gauge
- uprated filter
- cat back exhaust
- uprated plugs and leads
- drilled and grooved discs with uprated brake pads on the front
- decent suspension upgrade
- manifold
- adjustable actuator
- front mount intercooler
- decat
- adjust actuator to 0.8bar boost

you should see safe power of about 150-160 bhp

after this its up to you whatever you want to go for, either hybrid turbo, tdo4 or whatever
 
bigdoods

bigdoods

Member +
if i was starting again it would be...

greddy td06 turbo kit
cruise cam shafts
5e cruise engine
motec m4 ecu
and all the little bits:)

should see you up on 400-450bhp with a good tune lol
 
98_glanza

98_glanza

Member +
bigdoods said:
if i was starting again it would be...

greddy td06 turbo kit
cruise cam shafts
5e cruise engine
motec m4 ecu
and all the little bits:)

should see you up on 400-450bhp with a good tune lol
Click to expand...

not happy with what you have john :p :p

i would start with a set of coilovers
exhaust,decat,filter
actuator,fmic then maybe brakes
 
T

Toby@ToyTuning.com

Banned - DO NOT BUY FROM TOYTUNING
The good ol 200hp list springs to mind, we are going to start writing templates soon on tuning to help everyone out and to save reposts, hope this helps. We don't inlcude manufactures so it's as unbiased as possible:

• Hybrid CT9

• Free Flow Mild Steel Manifold

• Decat

• Cat Back system 2.5inch

The car is now expelling gases more efficiently.


• Relocated Air Filter to front bumper

• Heat Reflective tape for Inlet Track

Car is now breathing more efficiently


• Raise the Rear of the Bonnet with washers

• Front Mounted Intercooler (wrap throttle body side pipes with heat reflective material)

• Uprated Thermostat

• Rad Cap

• Consider better radiator and breather/header tank if planning on track days

Car is now cooling more efficiently


• New Spark Plugs (consider colder grades)

• New HT leads

• Inspect Dizzy/Rotor

Ignition system now works


• Uprated Fuel Pump

• Fuel Pressure Regulator Kit

• Engine Management/Piggy Back/Fuel Controller (depends how far you want to go)

• Rolling Road Session

Car now fuelling adequately


• Uprated clutch with flywheel is poss

• Quickshift Kit

• LSD if poss

Car can now handle power and you can shift quicker


This should net you around 180bhp - 200bhp on 18 psi max. This then leaves the brakes and chassis which will need to be sorted to cope with the power. I would recommend at a min:

• Uprated Front Disks

• Uprated Pads

• New OEM Rear Pads

• Braided Brake Lines

• Cusco BMCS

• Dot 5.1 Toyota Fluid (bleed dry and refill)

You can now stop!


• Coilovers / Fixed height shocks with springs

• Front and Rear Strut Braces

• Panhard Rod

• Lower Arm Bar

• Anitlift kit

• Check and replace worn bushes

• Good tires

Power to ground greatly improved.


That’s a basic list of what we recommend, obviously there are many more parts that will net you a good handling car that can stop with power to match but that should give you a good idea on where to take her pending needs.

This doesn't take into account basic servicing which is a must, make the most out of what you have no point adding mods until the car is up to scratch :)
 
D

destination unknown

Member +
thanks for all the replys wasnt really looking for anything in particluar just wanted to see what all ye would do!
if you were on a budget of a grand what way would you go?
 
You must log in or register to reply here.
Top