what timing are you running

J

Jo-Tech

Fresh Recruit
hi i want to know what timing you guys are running we have a glanza here on the island thad ran a best time of 12.97 @105mph i am running 20 psi and my timing is set @15 can some one give me an idea and i am running on pomp gas 98
 
G

GTdan

In The Closet
what other mods or is it still stock turbo, mani, exhaust filter etc?

when adjusting timing - it varies from car to car due to mods etc, aslong as its not knocking - it could knock at 5!
 
J

Jo-Tech

Fresh Recruit
ok it is a fulley build engine 1mm over forged rod forged pistons 4age studs metal head gasket it has a t3/4 turbo mated to a Jo-tech racing manifold microtech lt10 whit 440 injectors made @20 psi 258 hp and 197 ftlbs of torque but running on pomp gas not race fuel my best 60' was a 1.90 but when we ran the 12.97 it ran a 60' of 2.01 running slicks 23x7x15
 
L

Looseunit

Fresh Recruit
What is your base timing set at? 10 Degrees? If it is then 15 degrees advance sounds about right for that amount of boost. I was running base timing of 10 and running 15 degrees advance at full noise, that was stock 4efte. Only way to set it properly though is by using a detset to listen for knock.
 
J

Jo-Tech

Fresh Recruit
base is set @15 and i dont remember now what it is @ full song but it is not thad low it is higer than what you said
 
S

scatman56

Member +
the timing is variant for diferent setting depend,forge piston low mid and high ,head gasquet and compresion in cilinder and gasoline oct.....what turbo you use?
 
J

Jo-Tech

Fresh Recruit
ok it is a fulley build engine 1mm over forged rod forged pistons 4age studs metal head gasket it has a t3/4 turbo mated to a Jo-tech racing manifold microtech lt10 whit 440 injectors made @20 psi 258 hp and 197 ftlbs of torque but running on pomp gas not race fuel
 
You must log in or register to reply here.
Top