Recent content by morpheus

Thks a lot

Wee john ..found it.but there are 2 blue n white connected in parallel in the same connector..the other one goes where?

Hi does any one knows where it goes..i tried to trace it from them fuel pump...seems to go under the dash in a connetor.but cant see any blue white wire connected to the pump relay..could not trace it from the connector un the dash..where does it go?

Sorted...it was the relay...changed it..car ok now..thks

Hi guys..am having some intermitent problem sometimes the engine wont start and when i checked its the walbro not working and when i check the voltage on the blue and white wire just b4 the pump its zero...continued the troubleshooting till the connector under the dash still no voltage..am...

Hi am trying to adjust my tps. and each time its changing my timing..so. how do i proceed?which one to adjust first..was thinking about loosening both tps and distributor screw,move the tps till my timing is 10 degres and then tight sll the screws..is thak ok?

My batt is a month old..so dont think its the batt..a friend told me that i should tie the pump tightly. with cable ties is that true?

Hi..fitted a new walbro today also changed the fuel filter..now the problem is that the car hesitates to start..it starts only after 3 or 4 times after turning the ignition..it also hesitates under boost..seem to be a lack of fuel..wideband reading lean under boost..whats ur opinion guys

The one u need must have 2 pistons in each caliper.also the discs are much thicker than the glanza ones

Do u have the bzr supercharged twin pistons one..

278mm if am not wrong;-)

Yes mate 1000%sure as i did all job myself...ur disc diameter must be reduced to 260 mm.hope this helps

Mine is exactly 6mm..i machined my old glanza disc and use it as spacers..brake is awsome..with some green stuffs pads.;-)

Hi guys, will a 460 cc injector be ok to fuel a td 04l at 1 bar with all the supporting mods.an using greddy emu..wont they be too big..?i know stock one should be ok..but the are maxing out at .8 bar..what ur opinion.

Also does the O2 generates its own voltage or its the ecu that send the voltage and reads back..