Search results

Hi my car on a cold start it starts perfect but oce its warmed up & i go out to the shop & park it up & after shopping jump back i the car it doesnt always start first time but starts second time round bu=it strange what could be the problem with this ?? cheers

Hi As above wanted an adjustable panhard rod Preferbly a RSR one OR any other good one that can be adjusted whilst fitted on the car MUST NOT BE A WHITELINE ONE as i already have one & have to take the whole bar off for trial n error on the settings Let me know what u have cheers :)

Hi guys I've fitted a used whiteline panhard rod to my car but still have more of a arch gap on the passenger rear arch but passenger driver side has hardly no gap & whilst driving driver rear wheel scrapes onto the arch I've tried to adjust it but its a mins fuk cba with it now Any...

hi as above where do i get a main flash beam bulb from for a quadlight ep82 ?? tryed local motor factors but they dont sell OR anyone have a part number ?? cheers :)

Hi there guys seen a set of black rota GT3 alloys getting them at a really good price so they can be used on my other GT question is - these wheels are mint BUT a few bits around the edges of the polished lip have alight corossion like the laquer has peeled off & slightly corodded on the...

Hi guys as above was driving the car today been driving it on the new build for 300 miles now without any issues but up till today was out in the car driving & i hear a noise under the hood so parked up popped bonnet & to find out my new adjustable camgear is warped n rattles like f**k &...

Hi guys not been on here for a while been cracking on with my other GT some of u may remember my previous posts i had a very loud clunk/knock noise when turning full lock both sides found the problem - as i driver the car turn the wheels it clunks so loud BUT with the clutch down on...

hi as above where can i get one from?? for ep82 & for my glanza :)

hi guys this is my mates car but he is not on the forums right here goes again- basically we had the car on mates ramp other day & turned the wheel full lock to passenger side & as we turned the wheel full lock the outer cv boot was gettig twisted & we checked the drive shaft it had so...

Hi guys My last issue with the car is that - I have a LOUD clicking/clunk noise from when turning right & left in full lock Just to give u an idea Sounds abit like the wheels are scraping on plastic arch liners BUT its not I know it sounds like cv joints but i've changed the driverside...

Hi guys As above jus stripped my drive shafts out & want to know if this is normal my gearbox cups where the drive shaft goes into the cups hav some play in them (in/out) both sides Is this normal ??? Clips are on the splines too

hi guys as some of you might know i've been building my starlet for just over a year now aswell as building mine at the same time have been helping on my mates starlet too basically we've finally got his car up & running & after many nightmares we've finally got some braking pressure...

As above guys Wanting some good quality wheel nuts prefer the extra extra long lug nuts Longer than the D1's Cheers:)

as above my friends wheel nuts are coming loose even if he drives say bout 10 miles he's running 20mm wheel spacers on rear & 10mm on the front the D1's he purchased where from hong kong we have been told the steel lug wheel nuts are better is this true ??? as dont want to be...

Hi As above some of u may know i'v jus done a big engine build including fittting HEL brake lines So 1 month of trying to get brake pressure &. We have no brakes at all Just fitted a 2nd hand master cylinder & brake servo & still have no brakes at all Basically thres no brake...

Hi as above guys some of u may know i'm having a dilemma with my brakes as i have no braking pressure at all my question is - if there is a split in the rubber seal that goes around the brake caliper piston can it leak air or stop me from having brake pressure etc ?? as i have no...

as above i have a grinding noise from the front wheel near the brakes i had the brake shields powder coated so these wre off the car for months but they have been fitted for a week now & finally spinned the front wheels & i hear this grinding noise which is'nt the brake shield before this...

HI as above i've had trouble for a good few weeks now trying to get some brake pressure basically i've had the car off road for a year whilst doing a big build, about 2 months ago i drained the entire brake fluid & removed all calipers & all the brake lines etc, so basically the system was...

As above I have a cusco LSD installed in my ep82 I have jus put 3 litres of oil in there BUT it still seems to be not enough I wud have thought so 2.5litres would be enough I have used 3 litres so far How much do i need ??? Cheers :)

Hey As above worth having one or not? Car will be used for street use wont always be driving hard But will be doin some 1/4 mile strips Not sure if i should buy an oil cooler or not ? Recommendations ? Cheers :)