Search results

Hey Guys n Gals, I have had my head off to do the gasket, and now im syuck gettin the cams back in, i keep snapping the cam cap retaining bolts, even if theyre finger tight... Is there a guide on re-installing the cams anywhere? On a side note Toyota here in NZ want $5.04 per bolt to...

Back again.. let the noobness commence once more XD OK, you know the one just on top of the tappet cover with the pipe running to the intake body, I would post a pic, but that means stealing the batteries outta the xbox controllers for the camera XD...

:( My poor poor EP82. Has developed a nasty habit of missing when on boost... Runs on 3 cylinders... 4 when not on boost or not under load... I'm thinking the worst, and its probably time for a new engine :(

Just cruising that thread with the gt for sale in the chill out section, the starlet for sale with the NA intake mani... Has anyone fiddled with these mani's, and is there any gain to be had from running one rather than the standard one? What are they off, a corolla or summat?

Looking at replacing my rims and tyres at present (really i just need the tyres, but shh, dont tell the missus)... And what I want are some Work Meister S1/2 polished in 16"x7(.5)". What is the correct offset for a Starlet to avoid scrubbing? And am thinking of wrapping them in Nankang...

Well I figure that whilst me 82 is off the road for a few weeks (waiting for replacement radiator), I may as well sod around with a few other bits n pieces... I was considering gutting my cat, I dont think I will need to comply with emissions standards as the car is a '90 (technically those...

What should the voltage be set to for the O2 sensor on the Apexi full auto T-Timer be set to obtain (reasonably) accurate A/F readings?

Anyone have a crank lying around, or know off the top of their head what the diameter of the crankshaft nose is on the 4EFTE?

Um the topic really says it all... Will 4a pulleys fit the 4e? I ask because I came across these; http://www.trademe.co.nz/Browse/Listing.aspx?id=134384496

Do you change the water pump, or more to the point is it possible to do without lifting the engine / dropping the engine mount which is conveniently obscuring access to JUST ONE of the bolts?

I know this file has been floating around for some time (in fact I probably found it here!). But here is the service manual for the 5E. http://gafu.orcon.net.nz/Site/Med/15L_4_CY.zip http://gafu.orcon.net.nz/Site/Med/15L_4_CY.pdf (unzipped) I zipped it to save a bit of bandwidth, but all the...

Hey guys n gals, Has anyone had any success in changing the cam belt with the engine still in the car? Just looking at the amount of space available it looks as though it would be a ba*tard of a trick to pull off...