Search results

can you send to malaysia ? pm me the price + postage to malaysia harithnorman@gmail.com

not sure bout the a/r..i cud post a dyno graph though... my tuner says the turbo reach it max efficiency ( exzhaust fin is cerammic so he doesnt recommend any boost higher than 1.5 bar ) kon, so the 5efhe cams are enuff, just i need to get the correct turbo? thanks in advance

hi all.. 1st gear - until 7200rpm 2nd gear - until 8000rpm 3rd gear - until 8000rpm 4th gear - will release throttle as it will be end of drag strip rev limiter raised by emu.. but my 2nd gear will be too quick hitting 8k rpm...so when i shift to 3rd, it will require longer time to hit...

hi guys, would like to know what is the best spec for cams to be used on a 5Efte motor, running drag strip 350m - 400m current setup : fully forged internal, ( ross pistons n pauter rods ) 55mm throttle body 5e high lift cams speedvision valve springs 1.4 metal gasket acl bearing...

any help??

hi nick@TD can i have the screen shot of where to find the boost limiter.. is it on the vehicle parameter settings? very2 new to EMU here thanks a lot mate...

Hi All, anybody will be avail to provide me with the step by step guide to raise rev limiter on the emu? maybe can email it to me harithnorman@gmail.com thanks

any help guys thanks

so if ive wired it up according to the emu manual and follow the 2 screen shot on the below link it wont work ? http://www.toyotagtturbo.com/forums/...ad.php?t=18959 thanks

any help? does the launch control work on the ep82 ecu? thanks guys..

just opened the emu...yes its the 'E' version... danturbo4311: does your work with the ep82 ecu?

thanks on the first tab (Vehicle), do i change the engine size to 1500 as mine is a 5E ?

thanks Joz saw someone wrote... the emu with serial no 4000 and above no need to use the injector adapter #2....is the serial no the one at the back of the box? can anyone verify this...will be checking my emu later on

guys... i have an emu (not sure with version) with the greddy 3 bar map sensor.. i want to get this launch control working i am using the the ep82 manual ecu (2 connectors) i will be wiring up the emu as per greddy wiring diagram ( T6 ) can anyone repost to me the screenshot again on...

help guys... i have an emu (not sure with version) with the greddy 3 bar map sensor.. i want to get this launch control working i am using the the ep82 manual ecu (2 connectors) i will be wiring up the emu as per greddy wiring diagram ( T6 ) can anyone repost to me the screenshot...

thanks guys.. just want to confirm, when using the LT10s, i do not need to use the current ebc that am using right?

Hello guys, Just like to know you guys opinion, which is more worth it? Currently runnin fully forge 5e with emb...to run the quater mile... i was thinking of upgrading the ecu... Ultimate shud be sufficient as it eliminates the rev cut, but i got people tellling me it would be more...

thanks mate

thanks a lot mate. one more question, is there any special trick in wiring up the emb for the ep82 ecu, or we can just follow the diagram provided by greddy manual

all right, but what does this mean : u want the clamp the map sensor v at 4.1vs is it the setting in the emb? any pictorial i can refer to..