Search results

Hi all, Ive got the opportunity to buy a set of cams from a 5E-FHE. The only problem is they are coming from the early non-ACIS manifold version engine. Does anyone know if this early version of the engine had the same higher lift cams that the later ACIS version had? I have an EP82 with...

Hi all, Accelerating (WOT) up a hill a few days ago, my EP82's check engine light came on. Got home, checked the code, its 31 (MAP sensor). Im running factory ECU with a Jam FCD, boost is set a ~1 bar. I reset the ECU (no fault codes), went for a quick drive, all is good, no error...

Hi all, Is there a plug/bolt somewhere on the block to drain coolant? If so, where is it located? I need to get it all of the coolant out. Thanks.

Hi all, Sorry about the topic pun :p Has anyone had any port & polishing / combustion chamber work done to their 4E/5E heads? I just wondering whats been done, and what improvements were seen. Photos? Thanks

So i got a BHG, and have just pulled the head off to fix it. It was only a small BHG (pushing a little air/water into overflow bottle eventually draining the rad), clean oil. No obvious defects in the HG seal. This is how it looks.... #1 #2 #3 #4 #5 How does that look to you guys...

Hi all, I have 195/50/15's all round on my EP82. Recently new suspension went in which consists of Koni Yellow dampers and King Spring low springs. On a level road, at normal car weight there is approx a 1" gap between the top of the tyre and the guard. Occasionally during very hard...

Hello from Adelaide, South Australia. Ive had my EP82 for a few months now, and while i only bought it as a daily (i have a different project car, '77 Celica), im finding im spending time & $$s working on it anyway. Im having problems working out what build date it is though... The Aus...

Hi all, Just bought an EP82, doing the normal change of oil, filter, etc, etc. I want to empty the rad/engine of coolant and replace it with new stuff. The only problem is that the tap on the bottom of the rad only empties whats in the radiator. Is there a plug/bolt on the block...