Search results

hey guys can someone pls confirm the headbolt torque spec for me pls in NM measurement pls ive hada good look on the forum and found a few posts but im still unsure of the correct torque (is each bolt different) ......found a link which says torques for stage 1, stage 2 and stage 3? cud sum1...

advice much apreciated guys n gals.....wondering how much water/coolant the system should be holding roughly and how long should bleeding take? jus put the rad back on afta changing cat. ive filled the rad up whilst car running but it keeps bubbling up then circulating (im assuming this is...

im wondering if anybody knows where i may get a standard downpipe with catylic converter for the ep82 starlet? needed for MOT, cheers in advance

evening all so my 95 gt turbo has failed MOT on emissions- co excessive on 2nd fast idle,(the tester said its running very rich..does this mean its overfuelling) ive recently jus dropped new engine in and all seems fine apart from this- plus its idleing high about 1500rpm even when warm...

my drivers side window wont close??? ive checked the fuse and seems to be fine, i cant seem to get the passenger one to work either, so i dont think its the window motor etc, apart from a blown fuse what else could have done this does anyone know? or how i can test for problems to rule things...

ok guys n gals, so im halfway through an engine swap today and the driveshaft on my ep82 was so seized we had to give it a good bang to get it off an now its slightly bent! ....no problem i thought (i gotta spare on my donor starlet)......howeverr....mine has got ABS an the other car hasnt...

hey everyone, can someone please tell me if they know what transmission fluid for a starlet gt turbo ep82 gearbox??? found loasds info on here but cant find a thread specific to that and jus wanna check! much apreciated:rockon:

hi every1 wondering if some1 can help me please....my poor ep82 has been off the road for a few weeks now, knocking started from bottom end when i accelerate. ive been told my crank needs grinding and possibly need new shells...wont know what else till engine comes apart...but as it only...