Search results

Camshaft timing is perfect texx I drove in 300 Kms on it last night n it hasn't missed a beat .... And strangely hasn't misfired .. So looks to be all good She is a tad smokey when you boost n let off , releasing the pressure on the turbo so oil seals r gone ...

No didn't Change the plugs cus he never supplied me with some , I had a set of iridium plugs I ran in my tdo4 glanza and I tried them and no difference :/ .. Hardly just a set of plugs ?

I have. A few times .. It's all good.

Just done a head gasket for a mate in his glanza .. Before he gave it to me it had overheated and smokey . Now I have it all done . Head skimmed etc .. It's smokey when I come off boost . So that's the oil desk in the turbo gone .. But when I first put it back together it had a misfire when...

could you send me those part numbers aswell.. and does this final drive bolt into the c-series boxes all across the ranges. (including glanza)?... would u recommend putting in a 4age box or is that possible or just using a final drive from that box inside my glanza box? thanks

i guess i could but would like a professional looking finish... so hoping to buy some, sure ye make them n ill buy them off ye, ha

i need these so badly..anything around?

would you sell the defi controller seperate?

bump

im looking for new abs sensors, ep91 hand brake cables .. i know tm developments have the cables but just open to see if anywhere else stocks them?...

has nobody noticed the mirrors? its not a glanza...alsoits a 5zigen boarderline exhaust

bearings are very easily changed , providing theres no crank damage its as eas as open cap take out old bearing put in new one , torque it up and repeat this on the other ones and one ya go :)

would you deliver to ireland? pm me..

just looking for a rail to fit my recaro to my car, its a optionial levin recaro....i have a bride ep82 super low rail to swap for a ep91 rail

thanks..repped :)

i had a look and couldnt find any...any help? i can do a engine fitting perfect just curious to have a read through..

but becus the rack is pressure dependant would that not matther?

haha no i dont mean im by passing the matrix, im just saying that i look the steering rack pipes like you would bypass the matrix, just using the heaters as a comparison. thats all.haha have you got the power steering gone out of your car?

so basiclly loop the rack feeds? pretty similiar to looping water pipes to bypass the matrix heater box yes?....and throw away everything else ya? have you got it done with your car? and here i come with the stupid question, is there any power difference with the less stress

can i remove the power steering in my glanza and just plug up the holes in the rack? has it been done? or am i better off the find a ep91 with no power steering and use that rack?