Search results

Hi members, need your input on these: should the 4efte idle rich or lean? should it decelerate rich or lean? i am having idling issues and am out or idea on how to solve the problem: so far i have changed dizzy,plugs, spark plugs, fuel pump , calibrate the tps, check for any air leaks, timing...

Hi All, i need some info, as title said. I pushed the engine to '1.3 bar till redline on 3rd gear and when i opened the engine bay, there were oil everywhere. i didn't hear any rattle or whatsoever bizarre engine noise when trashing it. the engine now runs fine and no oil or fumes from the...

Hi Guys , as the title says, i badly need the oem part numper of the Glanza turbo. i have to order a new shaft (exhaust side). :confused:

Some new stuffs fitted Well bros just finished fitted some new stuffs on my car, the corolla AE101 with the 4efte. Front mount IC, FCD, FPR, Meshed Turbo, wide band kit and 6 puck carbon ceramic clutch and TRD pressure plate 200mm Tial 38mm wastgate fitted as an exhaust cutout just after the...

Hi lads, am in earch of an info, as the tite say all, has any one used the bosch ref 12210 on a Glanza or Gt? replies will be very much appreciated.

Hi bros , I have some question re an auto to manual swap. Car is an Ae 101 corolla, and swapped a 4efte engine in it and changed the gearbox from auto to manual, it still has its auto ECU with the 3 plugs (ECT printed on it) and the Car runs fine and pulls very well. The engine had had a Manu...

as title say,we just swap a 4efe engine in a Toyota corolla and the engine was running fine on the donor car. after fitting the engine it cranked and started normally, but pass 1/4 throttle the car bugs down and the manifold glows red hot on idle. we have checked all wires and all has its...

Hi all, as the title says has anyone ever attempt to do this?

As the title say, has anyone run his engine without the knock sensor, how has the engine cope? ECU cope? has timing been retarded? does the engine runs like crap ? all post are welcomed.

Helo bros, i have seen many thread on the site for TPS calibration for the GT (the 1 with 3 wires). so basically what i wanted to know is how to adjust the 4 wire TPS on the last GT genaration. The cars has been converted form auto to Manual but still uses the Auto ECU. if anyone has an...

Hi All, i know what ill ask is a bit fussy , but have to.... can any one explain how to use an adjustable timing light to calibrate the timing of my 4efte engine. i have a timing light with a round knob at the back which goes from 0% to 60% and i dunno on what degree to put it to adjust the...

Hi Guys, have a Toyota Corolla Ae 101 with a 4efte engine. spec of lightly modified engine are: light weight flywheel FCD FPR free flow air filter boosting 1bar FMIC (small one) straight 2" pipe from turbo to muffler (cta and resonator removed) The problem is the car does not seems...

I own a corolla AE101 with 4efte and some mods.:rockon:

hi all , am newy here, help will be very much appreciated. just done a turbo rebuilt and now boosting 0.7 only even if actuator removed, before rebuilt was boosting at 1.0 bar. checked all pipings ok. help