Any way to remove threaded stud from hub without removing the hub itself ,30mm bolt

danb87

danb87

South East England Area Rep
can you use 2 nuts?

do one right up on the stud, then use another an do right up against the first one. once thats done, start too work the inner one an should start too come loose dude. using some lubricant would probally help :)

thats how ive seen studs done mate.
 
dac69er

dac69er

Super Moderator
which stud are you on about? not the wheel studs?

or are you trying to remove the cv joint from the hub?
 
thechomper

thechomper

Member +
one of the wheel studs snapped today,i was told i could hammer it out ,but wondering does the whole plate with the 4 studs have to come of ,to replace the broken one
 
Jay

Jay

Admin
No there is a cut out on the rear of the hub to allow you to knock one of the studs out at a time. You can do this with the driveshaft and hub in place.

Jay
 
S

Skalabala

Member +
Knock it out, fit new one from behind if you have space...
Knock it in a bit then use wheel nut and washers or the wheel as a spacer and pull it in place by tightening the wheel nut.
 
You must log in or register to reply here.
Top