Anyone has diagram for this piggyback?

[elton]

Dear Sir,

I want to install a Haltech platinum interceptor on a 4efte. I have a unit in hand and i I am having problems creating a wiring diagram, confused between anologue and digital input signals. I have tried to trace and make a diagram from an evo8 but failed.

Do you think you can help me out? Also, no base maps are available for this car. Is it possible to run the Interceptor Platinum on a 4efte EP82 engine?

My installer told me that he wasnt sure which wires on the ECU are digital and analogue and he's afraid he cannot start the car after the haltech is wired in because he has no base map for this specific vehicle.


I hope you guys can assist me with these problems ;
1. Wiring Diagram / analogue and digital confusion
2. is a base map needed?


Your reply is much appreciated guys. Trynna make this happen!

P/S.... saw some thread in the AU starlet club, a black quad lite owner using the Interceptor. Tried to send him a pm on installation but no reply.

Anyone?

 

[Jay]

A few of the peeps in this thread might be able to help you, I have never seen one personally:

http://www.toyotagtturbo.com/forums/showthread.php?t=8126&highlight=haltech

 

[elton]

thanks mate, but even after reading the thread, im still not getting anything.

Well, same case here, im being sponsored an interceptor, no other options. Possible to wire it in?

base maP?

 

[sx_turbo]

you should pm starlet666 and see if he managed to fit it in the endand ask if he can give you some pointers

 

[elton]

thank you sir! Will pm him....
anyone else with any pointerS?

 

[nyahbingi]

haydn28 installed an EX6 recently on his i think, give him a shout