sard k24 finally booked in for mapping!!!

G

gaz_turbo1

Guest
what did the tuner say bout using 550 injector's, thought i would be better to use 330's, what ur fuel pressure set to
 

gt-harry

Member +
yea im fully qualified now matey, shame we could off nattered on about starlets rather than falling asleep in class lol :rockon:

hoping to push the k24 to the max, if it can hold the boost maybe up to 1.6 bar, my injectors are at 48 % at 1 bar so got plenty to go

clucth has gone now been in for 800 miles while i was running in mainly and now it slips when hard boosting in 5 th gear its a 3 puk excedy clucth i got from ebay, brand new and it came in the right boxing!!! :(

so will have to get new clutch now i need one that will take up to 300bhp and that will not wear out with daily driving an y suggestions???? p.s. im not maid of money lol
 

Nick@TD.co.uk

Registered Trader <a href="http://www.TuningD
yea im fully qualified now matey, shame we could off nattered on about starlets rather than falling asleep in class lol :rockon:

hoping to push the k24 to the max, if it can hold the boost maybe up to 1.6 bar, my injectors are at 48 % at 1 bar so got plenty to go

clucth has gone now been in for 800 miles while i was running in mainly and now it slips when hard boosting in 5 th gear its a 3 puk excedy clucth i got from ebay, brand new and it came in the right boxing!!! :(

so will have to get new clutch now i need one that will take up to 300bhp and that will not wear out with daily driving an y suggestions???? p.s. im not maid of money lol
Save up and get the ORC single Plate! well worth it and it has the flywheel as well, shame ye, still hopefully meet ya at pod or a meet or something? ill have to fall asleep in class then :p

~Nick
 

gt-harry

Member +
ha ha thats what i did sleep, sleep and more sleep ill never no how i got qualified lol

how much do those clutches go for then??
 

Kelly

Member +
nice result gt-harry!!

we have the 550cc injectors too! really thinking about stealing your manifold tho!! :p
 

gt-harry

Member +
nice result gt-harry!!

we have the 550cc injectors too! really thinking about stealing your manifold tho!! :p

ha ha keep your hands off lol

what does yours rev round to kelly? mine hits the limit at 7 so i take it around to roughly 6,500 rpm usually
 

Kelly

Member +
the boost drops down to 1bar at 6k revs so thats when we change gear! its weird as it hold boost solid until that point, thinkin the jam manifold may be the cause? hence why we want the sard one!
 

ben_j

Member +
hiya, mines the one running the blitz k24 set up. you got any graph's? i'd like to see a boost against rpm for yours and a bhp against rpm too dependin on wat ya got, see how mine compare etc.
 

Dan3SGTE

Member +
207HP @1BAR.....

do the TD04's not produce even more then this....? i remember a few making over 200HP just @0.8BAR....

still not a bad result especially when you run higher boost, bring on some real power......
 

Kelly

Member +
will it make even more power at 1bar again with the leak in the inlet mani?

bens k24 made 203bhp at 0.80bar i havent seen td04's make this?! could be wrong tho! just going off recent stuff?!
 

Gee

Member +
The good old K24 vs TD04L debate!

K24 is all about low down torque and wont make as much power as a TD04L at the same pressure...FACT!

All about what you want from your car!

Nice result mate.
 

Dane_Bristol

Member +
I agree with Gee, and thats comming from a K24 owner !. The K24 aint the biggest of turbos and the theory of it making HUGE bhp is a myth. Only if you are going to go all out like Toby did using extremely high octane fuel and various other performance parts.

The K24 was made or torque i dont think the TD04 will make the same Torque level at the same PSI than a K24 but this still needs to be tested.
 
Last edited:

Dan3SGTE

Member +
cool cool............

different turbos for slightly different applications.... Sorry i just thought the the two turbos had very similar characteristics therefore were very comparable...
 

Kelly

Member +
yeh thinks lots of ppl compare them its how we learn i guess.
i love the torque and spool of the k24 tho :)
 

gt-harry

Member +
yea i am really pleesed with the k24, im not at all bothered about the bhp level altho it is allways interestng to no, the k24 just hits boost and pulls very hard and when you have a sard screamer pipe like me it puts a very, very, big smile on you face!!! ha ha lol :rockon:
 

gt-harry

Member +
yea i have but i have not got a scanner so i will hav to take a pic on my phone and post it up!!! ill try and do it tonight im going to eqypt for a week so will prob do it when i get back as i got to pack:)
 

kingyglanza

Member +
LOL I guess that was you last night along the M2. FOOOOK me does your car shift. I was the white Glanza. Very impressive spec list you got there. Where you from mate?
 
Top