aaronw
Member +
the corsa ive been offered
Engine.
C20LET engine conversion, ported and polished block, Mhale forged pistons, crank
polished and balanced, steel h section rods, modified bearing shells, uprated
oil and water pump, phase 3.5 ecu software, walbro 255 fuel pump, saab red
injectors, 1.9mm steel head gasket, 60mm intercooler and boost pipework, denso
iridum sparkplugs, regal inlet modified xe cam, front mount intercooler (sprayed
matt black), enlarged tophat, slim line fan, adjustable 6bar fuel reg, manual
boost controller, straight threw 2.5'' exhaust, custom engine mounts, chris
astley hubs and shafts, f28 6 speeed box with short shift.
Brakes.
Wilwood 4 pod callipers, braided brake lines with Wilwood pads (they were fitted
about 500 miles ago) with drilled and vented discs.
Suspension.
Coilover front suspension and adjustable rear suspension.
Interor.
OMP TRS seats, 4 point harnesses, momo steering wheel, roll caged, rear is
stripped out, battery in rear wheel well, boost gauge in drivers vent.
Bodywork.
Standard bodywork apart from Compomotive 5 spoke alloys with Hankook RS-2 tyres
and wind deflectors.
The best bit...Performance!
0-62mph- 4ish seconds
Top Speed- 170mph+ (ive had 173mph and still some to go).
Bhp- 300+ (regal software 3.5 is 320bhp with correct upgrades)
Weight- 870kg
Only bad bits are;
. Bodywork isnt 100% as i wasnt intersted in looks as it added to the whole
sleeper image.
. Driver mirror glass is cracked (brought it like this and never bothered
changing it).
. Speedo doesnt work as i snapped the speedo cable due to the speeds its capable
of and the original clocks only going to 130mph.
plus £1250
Engine.
C20LET engine conversion, ported and polished block, Mhale forged pistons, crank
polished and balanced, steel h section rods, modified bearing shells, uprated
oil and water pump, phase 3.5 ecu software, walbro 255 fuel pump, saab red
injectors, 1.9mm steel head gasket, 60mm intercooler and boost pipework, denso
iridum sparkplugs, regal inlet modified xe cam, front mount intercooler (sprayed
matt black), enlarged tophat, slim line fan, adjustable 6bar fuel reg, manual
boost controller, straight threw 2.5'' exhaust, custom engine mounts, chris
astley hubs and shafts, f28 6 speeed box with short shift.
Brakes.
Wilwood 4 pod callipers, braided brake lines with Wilwood pads (they were fitted
about 500 miles ago) with drilled and vented discs.
Suspension.
Coilover front suspension and adjustable rear suspension.
Interor.
OMP TRS seats, 4 point harnesses, momo steering wheel, roll caged, rear is
stripped out, battery in rear wheel well, boost gauge in drivers vent.
Bodywork.
Standard bodywork apart from Compomotive 5 spoke alloys with Hankook RS-2 tyres
and wind deflectors.
The best bit...Performance!
0-62mph- 4ish seconds
Top Speed- 170mph+ (ive had 173mph and still some to go).
Bhp- 300+ (regal software 3.5 is 320bhp with correct upgrades)
Weight- 870kg
Only bad bits are;
. Bodywork isnt 100% as i wasnt intersted in looks as it added to the whole
sleeper image.
. Driver mirror glass is cracked (brought it like this and never bothered
changing it).
. Speedo doesnt work as i snapped the speedo cable due to the speeds its capable
of and the original clocks only going to 130mph.
plus £1250