Search results

Is it safe to have watstegate chatter on a TD04 at 14psi or should I be running some sort of BOV/Dumpvalve? Thanks!:cool:

Hi all, Recently went TD04 with a full WEPR kit on external gate, had it all set-up by Mike at Monster Motorsport then the turbo seals went on my TD04L so replaced it and got a garage to spin the turbo for me (didnt have big enough circlip pliers lol) fitted it all back together went for a...

After a working good condition set of 460 injectors (SARD) that are a direct fit for an 4efte ep91 my 330's maxxed out on duty cycle on my td04 set-up. Mike at Monster Motorsport advised me to get some 460's! Cheers Brett ;)

After both sets of headlight adjusters for an ep91 mine have snapped and I cant get my glanza through MOT because I cant adjust the headlights! and also a bonnet stay as for some reason ive never had 1! :haha: Thanks! Brett

Hi all, Bit of help needed would I find it better to externally gate my CT12 set-up would it reduce my lag? not getting full boost until 4500rpm and then the power graph when I had it dyno'd goes pretty much vertical! Any advice is appreciated! Brett

Hi All, Just had a turbo smart boost tee fitted to my ct12 glanza, is it possible to run the boost tee into the cockpit so i can adjust the boost from inside or will i just end up with loads of lag because of running the pipes through the car? Brett

Hi All, When I accelerate in my glanza the boost is at 0.5 bar and when it reaches 4000rpm rises to 1.0 and then past 1.2 bar before 6500rpm! I am running a ct9 Hybrid which was rebuilt 2 months ago by Turbo Technics and they fitted it with an actuator and told me it was set to run 1.0 bar...

Hi guys, Had my glanza on the rollers a few weeks back and she made 163BHP at the wheels at 6350rpm is this any good? Mods are: CT9 Hybrid running 1.0 bar Autobahn 88 FMIC Blitz Manifold Decat Full stainless steel exhaust system RRFPR TRD Leads Air filter relocation FCD Lightened...

Hi all, Just done a engine change on my ep91 previous owner decided he could build a forged engine which left me with a destroyed block when the conrods decided to escape! Anyway decided to just run a standard 4efte engine with my ct9 hybrid turbo on it for now until i can afford to go forged...