gorganl2000
Lifer
being from malta, you should have a lot of local experience to draw on...some very knowledgeable guys over there regarding ep82/91 builds
I hope you are still here. So I bought 4efte camshafts from Japan to replace them in a 4efe head pff a 1098 Corolla to go on a 4efte engine. I am using the 4efe block and replacing thermostat housing and oil relocation bracket. Putting a 3/4” pipe in the sump. Not sure if the oil strainer is the same between engines. If not ai will swap them.did a head job on my car abt a year ago i belive the replacement head was off a 4efe as it had an extra water passage where the inlet sits, i used the cams of my 4efte head and go it re-shimmed and also had it inspected by engineers who advised it will run perfectly, its been running 1.2bar with no issues what so ever