### EP95 turbo conversion ###

[cole]

okay cheers

 

[AzE_B]

yeah got a little pic i will send ya

send to me aswell

 

[_GAZ_EP85_]

mark it all up

cut it out, used a **4"** box section and a set of top mounts cut from scrap starlet, cut them down and welded to the top of box section,

and get the local grease monkey to weld em in

 

[cole]

mark it all up

cut it out, used a 3" box section and a set of top mounts cut from scrap starlet, cut them down and welded to the top of box section,

and get the local grease monkey to weld em in

lol thats diy at its best

 

[_GAZ_EP85_]

well it's a bit expensive to get a machine to do it
and it helps if you no what your doing

 

[cole]

well it's a bit expensive to get a machine to do it
and it helps if you no what your doing

can you make any more

lets start a group buy :rockon:

1 cole :haha:

 

[AzE_B]

and get the local grease monkey to weld em in

ME

 

[_GAZ_EP85_]

it was not as easy as the 2 pics show, loads of marking up and making sure everything is spot on as it was before used a few technics to make sure thats it's perfect:rockon:

 

[cole]

so basically its just like a spacer so the shock sits lower

eh ive just confused myself it would sit higher with a spacer in

 

[_GAZ_EP85_]

your basically raising the top mount position so that the shock sits higher up in the body, will raises the axle

 

[AzE_B]

what will make the car lower lol

 

[cole]

oh i get ya so u chop the old 1 out and weld this new 1 in

is that safe lol ?

 

[_GAZ_EP85_]

well done aaron gold star for you and REP POINTS:haha:

 

[AzE_B]

oh i get ya so u chop the old 1 out and weld this new 1 in

is that safe lol ?

he hopes so

 

[_GAZ_EP85_]

you hope so you bloody welded it up,
na should not be a problem, welding is proper fat and metal super strong:rockon:

 

[cole]

with stiff coilovers i bet that putts some right stress on the weld

 

[_GAZ_EP85_]

Yeah true but if the welds are good then there shouldn't be a problem, have seen engine conversions with thinner guage metal and not as good welding compared to this mod

 

[dantheman]

says the one that i have never seen drive faster than 50mph:kiss:

 

[cole]

Yeah true but if the welds are good then there shouldn't be a problem, have seen engine conversions with thinner guage metal and not as good welding compared to this mod

how bad does it sit without the mod

wouldnt some coilovers on the lowest setting be sitting okay i dont want it megga slammed

 

[dantheman]

hope arrens welding skills are up to scratch.. and hope you welded it on the under side aswell as on top like i was saying the other day..? especially with the way you drive! i suppose you got that rollcage now though just incase