forged pistons in glanza help needed

[JasonG]

well lads!!just wonderin if i put bigger pistons in my glanza wat power wud i be lookin at???and would it increase boost and power also???my glanza is currently standard anuf yoke...also running normal ct9
help will be repped thanks...

 

[whiteglanzav]

use a search mate putting bigger/forged pistons in is a base for getting a bigger turbo thats able to run more boost

 

[Mark-ep91]

firstly forged pistons wont give you any extra power there just build better and stronger to take more boost and not blow!
what power are you looking for and ill give you some advice on how to get it?

 

[JasonG]

firstly forged pistons wont give you any extra power there just build better and stronger to take more boost and not blow!
what power are you looking for and ill give you some advice on how to get it?

well 200 mark or even 180 boostin 1 bar lad...

 

[JasonG]

use a search mate putting bigger/forged pistons in is a base for getting a bigger turbo thats able to run more boost

okay thanks will ave alook!!

 

[Mark-ep91]

well 200 mark or even 180 boostin 1 bar lad...

have a look here lad http://www.toyotagtturbo.com/forums/showthread.php?34351-Well-balanced-200bhp-Look-inside

no need to go forged unless you pushing over 220bhp

just looked there its missing some stuff basically ya need decat,exhaust,free flowing mani,hks actuator,fmic and u would be making nice power at .8 bar then buy a fpr and fcd and get the set up by a mapper on a rolling road to 1 bar and would be around 180-190 bhp but thats bout 220bhp per tonne lad so fairly fast in a glanza hope tis helps

 

[J25GTi]

No need for any engine work. Ct9 at 1bar would be fine for what u want

firstly forged pistons wont give you any extra power there just build better and stronger to take more boost and not blow!

what power are you looking for and ill give you some advice on how to get it?

well 200 mark or even 180 boostin 1 bar lad...

 

[JasonG]

have a look here lad http://www.toyotagtturbo.com/forums/showthread.php?34351-Well-balanced-200bhp-Look-inside

no need to go forged unless you pushing over 220bhp

thanks lad

 

[JasonG]

No need for any engine work. Ct9 at 1bar would be fine for what u want

soo just set the boost to 1 bar???

 

[Aidan@EP-styling]

soo just set the boost to 1 bar???

You need:

Ported manifold if not an uprated manifold.
Downpipe
Cat back exhaust system aftermarket
Front mounted air filter relocation kit
Front mount intercooler
HKS actuator to set boost at 1 bar
Piggy back ECU to set up the AFR ratios

 

[JasonG]

You need:

Ported manifold if not an uprated manifold.
Downpipe
Cat back exhaust system aftermarket
Front mounted air filter relocation kit
Front mount intercooler
HKS actuator to set boost at 1 bar
Piggy back ECU to set up the AFR ratios

thanks aidan

 

[JasonG]

you'v all been repped!!

 

[druspeed zone]

hi buddy
i want to know about the difference betwen ct9 and ct9 hybrid 2 nd genertion ?
and if it stands the standard pistons cause it say 12 psi and dail 14-17psi daily