Hi
I recently fitted a Mitsh td05h 16g on my ep91 5efte setup. I had the stock ct9b turbo which was mapped using a unichip. The car had been sitting for about 3-4 months before all was fitted. When all was completer on the 1st test run I noticed a flat spot at 3.8k rpm all the way to 4.8ish k rpm then opens up. I never had this problem before the upgrade and expected to run lean but its the opposite situation.
I am aware I need to get it remapped but before doing that needed to make sure all else was fine as its a long drive. My diagnostic test just has the light constantly flashing so from what I read all is fine. I also checked all the pipes for leaks with no leaks detected.
I assumed the unichip was the culprit and decided to disconnect it to test, started her up and the idling was terrible and after another diagnostic test without the unichip I got code 31. Has anyone experienced this and will another visit to Dastek resolve this or is another map sensor required.
I have a spare ep82 map sensor but when i connect it makes zero difference. any other ideas suggestions are greatly appreciated.
Thanx
I recently fitted a Mitsh td05h 16g on my ep91 5efte setup. I had the stock ct9b turbo which was mapped using a unichip. The car had been sitting for about 3-4 months before all was fitted. When all was completer on the 1st test run I noticed a flat spot at 3.8k rpm all the way to 4.8ish k rpm then opens up. I never had this problem before the upgrade and expected to run lean but its the opposite situation.
I am aware I need to get it remapped but before doing that needed to make sure all else was fine as its a long drive. My diagnostic test just has the light constantly flashing so from what I read all is fine. I also checked all the pipes for leaks with no leaks detected.
I assumed the unichip was the culprit and decided to disconnect it to test, started her up and the idling was terrible and after another diagnostic test without the unichip I got code 31. Has anyone experienced this and will another visit to Dastek resolve this or is another map sensor required.
I have a spare ep82 map sensor but when i connect it makes zero difference. any other ideas suggestions are greatly appreciated.
Thanx