Stock FPR Setup

[Smore]

Putting my car back to stock and selling all the bits so need to find out how the stock FPR is setup and where the pipes go etc, i can't remember

Thanks in advance

 

[sx_turbo]

there should be a total of 3 bolts that hold the standard fpr in place.

2 at the end of the rail drivers side, and 1 the other end. then you have a rubber pipe on the end of the fpr passenger side going to the fuel return.

 

[Smore]

there should be a total of 3 bolts that hold the standard fpr in place.

2 at the end of the rail drivers side, and 1 the other end. then you have a rubber pipe on the end of the fpr passenger side going to the fuel return.

only one pipe, ah ok, thought there was more hence the confusion

thanks for clearing it up sx

 

[Jay]

From my personal research:

 

[Smore]

thanks Jay!!

 

[Smore]

jay, just put the stock fpr on(upside down i might add until i saw this pic lol) but anyways, i can't find my pipe that goes from the fpr to the right of the engine then rubber hose to the return line

if you have these parts, may i have them please

23802D - Washer
23802C - Washer
23801P - Metal pipe
90119-08145 - Bolts