dac69er
Super Moderator
from reading a few posts it looked as though you just fit the new sensor, select it on the commander or setup the offset and scale and then your map will be fine.
i just recently got a new map sensor from an st205 which should read a bit higher than stock, selected sw20 sensor as its the same and the car runs fine, boost reading matches my boost controller so looks good.
only problem is my fuelling seems to have richened up a bit. by approx 0.5 afr across the whole scale. i have the datalogit software so i can just knock the whole fuelling map back until i was back to where i was. just wondered if this was normal or if i missed anything?
i just recently got a new map sensor from an st205 which should read a bit higher than stock, selected sw20 sensor as its the same and the car runs fine, boost reading matches my boost controller so looks good.
only problem is my fuelling seems to have richened up a bit. by approx 0.5 afr across the whole scale. i have the datalogit software so i can just knock the whole fuelling map back until i was back to where i was. just wondered if this was normal or if i missed anything?