Peoples
Can anyone tell me the recommended HOT SIDE FMIC piping for GT2560R on a 1300cc.
2" 3/8 or 1" 3/4 (hot side)
cold side is 2" 3/8
Would the 2" 3/8 be to laggy or would the 1" 3/4 be to restricted
anyone tried these setups
Trying to find the ACT Xtreme G6 clutch kit number for the 4efte engine.
On the ACT site they say that the 4efte is not offered in the USA and they can tell me if the kit they have for the 94 tercel with the 3E engine TL2-XTG6 can work for my application.
Did anyone use this kit on a 4efte
Had some Gt rear disc installed on my EP70 some years back. I had to get a metal sleeve installed in the hub so i could use the ep70 bearing. I had to do this because the GT bearing was to big for the EP70 back arm. Can anyone tell me if EP71 work the GT disc with out this setup
Carried out a diagnostic test the other day and got these two error codes,
RPM signal Code (12) and Turbo pressure signal code (34) .Just want to know what problems am I dealing with and if serious what steps to take next.