well just to state im not slagging off the product. could just be a user error.
is anyone else who is using the hdi ebc have problems with erractic boost?
basically i fitted the ebc, took it out on a test run and all was well. didnt really give it a big test just a couple of runs to set the controller to just under 1 bar. all was working fine.
its happened twice now where the boost has just shot up uncontrolably to about 20psi before i noticed so would have kept going i feel if i didnt jump straight off the pedal. then after that it just went back to the boost i set it too. it done it in 3rd gear, at about 3500 rpm then foot to the floor it flew up to 20psi.
i had no problems with boost creep or anything before when ran just on the hks actuator, held boost and never crept so its not that.
its running fine again at the minute but im very wary as i you can not always keep your eye on the boost at all times.
any ideas?
is anyone else who is using the hdi ebc have problems with erractic boost?
basically i fitted the ebc, took it out on a test run and all was well. didnt really give it a big test just a couple of runs to set the controller to just under 1 bar. all was working fine.
its happened twice now where the boost has just shot up uncontrolably to about 20psi before i noticed so would have kept going i feel if i didnt jump straight off the pedal. then after that it just went back to the boost i set it too. it done it in 3rd gear, at about 3500 rpm then foot to the floor it flew up to 20psi.
i had no problems with boost creep or anything before when ran just on the hks actuator, held boost and never crept so its not that.
its running fine again at the minute but im very wary as i you can not always keep your eye on the boost at all times.
any ideas?