Time to get her on the rollers!

Captain Starlet

Captain Starlet

Member +
Well all booked in for 3pm today to see what she can do.

Hoping for 300 though wont be disappointed with 280+

the spec (most will know as of who built it)

Fully forged engine including:
Wiesco low compression 74.5mm pistons
Pauter Steel rods
TRD 0.6mm headgasket
Speedvision Billet 265 degree cams
Custom spec headwork by ccm
460cc injectors
NGK Iridium heat range 8 plugs
Autobahn 88 silicone radiator hoses

Turbo and Exhaust
Full Zisco TD05 turbo kit including:
Externally gated mild steel ram style manifold fully braced
TD05H 16G turbo
Filter relocation kit behind front bumper
Decat downpipe
HKS HI Power exhaust system
Tial 38mm wastegate and screamer pipe
Autobahn front mount intercooler

Electronics
Blitz Dual SBC boost controller
E-manage Ultimate piggyback ECU with 3bar map sensor, field harness.
Walbro 255l/h fuel pump

On the day will be running it at 1.5bar... so heres hoping!

Speak soon!
 
Rory

Rory

Lifer
Who mapped it buddy?
And whos rollers you going on?

Also see if you can get a boost trace with your graphs please, :)
 
After-Glanza

After-Glanza

Member +
Good luck with it mate, hopefully gets figures to match how well it goes on the road. It made 275 or so on the td04 at less boost so should make good numbers. As far as I know there is loads left in the car as Chris said we could get it going much better if he could tune it in the rollers :)
 
Captain Starlet

Captain Starlet

Member +
After-Glanza said:
Good luck with it mate, hopefully gets figures to match how well it goes on the road. It made 275 or so on the td04 at less boost so should make good numbers. As far as I know there is loads left in the car as Chris said we could get it going much better if he could tune it in the rollers :)
Click to expand...

yeah heres hoping chris, If the figures dont come up trumps ill be heading to get the ignition mapped that lil bit better on the rollers
 
Rory

Rory

Lifer
Was this engine not in a car in Ireland?
All RR measure in WHP, thjey give FWHP for bragging rights, which is a waste! :p

Cheers, want to see how the 16g behaves.

Captain Starlet said:
Chris from ccm mapped her rory,

im heading down to gmc motorsport. What i like about these rollers there in whp!

will do!
Click to expand...
 
Captain Starlet

Captain Starlet

Member +
Rory said:
Was this engine not in a car in Ireland?
All RR measure in WHP, thjey give FWHP for bragging rights, which is a waste! :p

Cheers, want to see how the 16g behaves.
Click to expand...

Correct!

yeah it is a waste all im interested is in the whp.

Looking forward to it to see if that extra bit of lag is worth the wait over the 04
 
sx_turbo

sx_turbo

Lifer
they give fly horsepower for accuracy reasons.

to many variables like tyre pressure etc affect wheel horse power, so they measure the rolling resistance and calculate from there,

any hoo, good luck with the results car sounds awsome
 
You must log in or register to reply here.
Top