Search results

COP setup (Coil on Plug) direct coil on ignition connector Hi Guys a few Questions 1. is this a better option than multiple coils? (my theory is that im trying to eliminate the "wearable" items like leads, rotor etc.?) 2. is this coil physically attached to the plug?, meaning that if a...

Hi Gents tried really hard with the search facility.. promise!!.. but i cant seem to find the thread.... im hoping to go to the local import shop and get a 5EFHE.. how would i visually distinguish between the two engines?... i think it only says 5E on the block on both versions of the engine...

ok i got to admit to being a total noob when it comes to electronics. i would really like to know how a stand alone fuel management system (some at least) would control normal "base" (all four cylinders) timing, then maybe i would get some clue on how individual cylinder timing works.. im really...

Hi Gents Where would be the most appropriate/ideal location on the ep82 block to place the DIY knock "sensor/pickup" ... i take it has to be ideally situated where one can pickup equal potential pinging/knock from all four cyclinders .. im no expert at this so please feel free to rectify me...

Okay guyz, iv done some research and got some contrasting opnnions on the exact location for best results for the placement of the exhaust gas temperrature sensor in the exhaust system this is a comment i got from the a honda forum: "the best place to put it is about 2 inches away from...

Hi Guyz, i would liek your opinnion on these (refer to pix below) I know that Type-RJ regulators offer stability of fuel pressure under high boost of high performance vehicles with its high-capacity body and diaphragm. but how much more stability that the regular type (that some traders sell...

the lead from the distributor to the coil, I need to change the one end to a “boot type” connection to accommodate the coil end, but the leads I imported got both clip type connectors on both ends, could I change the ends myself or should I get a pro to do it, or can I get any lead that fits on...