marty
Member +
Have a cracked stainless exhaust manifold sitting in the garage that I want to put back on the car as the cast ported one I have is showing signs of cracking now too.
I have a bit of experience so just looking to weld it myself but have a question about welding rods for you keen welders out there.
The manifold is T-304 stainless and I was planning on using 1.6 - 2.0mm 316 rods.
Only done wee bits and pieces with stainless before so any information appreciated!
Cheers
I have a bit of experience so just looking to weld it myself but have a question about welding rods for you keen welders out there.
The manifold is T-304 stainless and I was planning on using 1.6 - 2.0mm 316 rods.
Only done wee bits and pieces with stainless before so any information appreciated!
Cheers