auto to manual conversion - car now wont start!? help :)

[FealScott]

hi basicly i have a 1998 glanza v which i have just done a manual conversion to which i took the engine out to do as i had other parts to fit so was easier to take the engine completely out, basicly i have everything hooked back up now and i have bridged the wire from the big plug on the autobox so that the car now turns over but wont start, the car isnt sparking and fuel came out the rail when i loosened the nut and turnd the key, but spark plugs were dry. also when the car is turning over it is slower than before and there seems to be a strain on the starter motor, when jump leads are on the car it turns faster but the noise is still there,

i have checked all fuses, checked earths aswell.
still using the auto tps, and auto starter motor

any help appreciated!

 

[weeJohn]

Do an advanced search mate, all you need to know has been covered before.

 

[gtpower]

isnt there somthing to do with a switch on the igntion or somthing stops the car starting if it thinks its in gear kills the spark or somthing

 

[FealScott]

Do an advanced search mate, all you need to know has been covered before.

hi, i have done an advanced search, cant find anything that covers the symtoms i am getting.

im going to buy another auto ecu and try that in it.

 

[Rev]

This gives a little background to the auto tran connections.
I have had an auto car not starting due to the rubber in the brake switch crumbling the switch was not making contact this is worth considereing.
http://www.autoshop101.com/forms/h16.pdf

 

[wildchild]

are you sure you earthed the wire on the opposite side of the throttle body on the inlet manifold? its the injector earth. if its loose or not fastened to the mani then ur injectors wont open.