gud u sorted bud
what injectors are u putting in?
its very simple, so set the base pressure at 2.5bar...
go on the parameters values & change the i/j lag times so that u get the new injectors to work like 295cc's
it should look something like this (EXAMPLE ONLY!)
before 295cc after 324cc
0.20ms 0.00ms
basically u ONLY increase the values on either side, now iv tried many things, if u adjust the lag time on the "after" area ur not gonna be happy.. coz it will rich things out, throughout the rev range,
with ur wideband in hand, slowly increase the values (in 0.05ms steps) till u get around 14.7~15.5 AF) on idle & drive normally to ur tuners
that way u shouldnt have any problems at all boss...
just remember to change the ignition reading (on parameters page 1) to read ignition otherwise ull have bad values & cant use launch control
kon