Will a different map sensor work? For example 3sgte 2 bar one? With part number 89420-17030. Can someone confirm for sure. Because I can’t find any 4efte one
If you suspect the waxstat pop the intercooler pipe off the throttle body and you should see the vacuum port in the housing. The waxstat controls how much air gets into the system through this.
If you put your finger over it and the idle starts behaving then you've found your issue. Sometimes the wax in the waxstat breaks up and that port remains open even when the engine has warmed up.
Failing a fault code being present it's a bit difficult to guess unfortunately. Check the codes when you are checking the air feed port and report back.
Engine warm, put my finger on the hole inside the TB and it stalls. Is that normal for the waxstat?
also here is the symptoms I’m getting
-Burning excessive fuel (smell and sputters from exhaust)
- idle is jumpy and high
-idle screw is all the way in and still idle is around 1200 rpm
-i have new stock injectors in
-stock fpr
as my idle is high I need to adjust to make it less, but it's already all the way in (low idle). If I unscrew it I'll get higher idle than I already have..
if that makes sense
I'm thinking of a few things, maybe my stock fpr is no good anymore, reason being excessive fuel burning.
But can't figure out the the high idle issure.
TPS I tried adjusting and it seemed good.
I have a new air intake temp sensor on
IACV was cleaned
Is the waxstat suppose to make a hissing sound? It’s coming from the port that Jay told me to block off. When I blocked it off, engine dies
Any help please