Search results

For sale: For sale is my top spec Vectra Elite! It's a 2006 on a 56 plate, clocking in at 64,000 miles. The car started off life as a Vauxhall fleet car, so has allways been maintained properly by Vauxhall, and has continued to have been serviced by them in the service history book, showing...

For sale: Brand new pair of rear discs to fit your ep82 ep91... genuine Toyota. Do NOT come with bearings. non ABS Item Condition:New Price and price conditions: £60 + £10 postage + fees if using paypal Extra Info:n/a Pictures: Contact Details: call 07776088940 , email ...

has the TGTT stickers, seen it parked up on the tower estate a few times. looks very tidy!

...In style!!

Amazing fail by some corsa owner (typical) http://www.corsa-c.co.uk/forum/showthread.php?t=184051

Toms kitted EP82 with hybrid **£2700** For sale: 94' Starlet GT EP82 Item Condition: used, but good Price and price conditions: £2700 ONO Extra Info: Make; Toyota Model; Starlet Engine:1300cc mileage , just over 100k Modifications Engine: Tong turbo's GT spec hybrid...

Tempted to get shot of the starlet and get an old RX7. can anyone give me a price guide for my car? here is the info: Make; Toyota Model; Starlet Engine:1300cc mileage , just over 160,00kms Modifications Engine: FSE fuel pump JR breather filter Tong turbo's GT spec hybrid Toy tuning Front...

Our story begins when Local hero (me) purchased his new blitz cooler. Coupled with my blitz super sound bov it would sound quite funky. But, ever since i've had the FMIC i've had problems getting a bov to work. My blitz super sound worked fine on the tmic, but when i switched to a fmic setup, i...

gay topic i know, but are any shops open? need some drain unblocker so i can do the heater matrix on the car today for something to do!

RHD have sent me a postcard in the mail today saying they have enrolled me in their lottery? did anyone else get their 'lottery ticket' today? it's uber cool

After the plastic panels on the outside of the doors , both sides of the ep82, must be black and good condition ( the bit that says gt turbo ) thanks :)

Is there any way of repairing or refurbishing my blitz super sound? It seems to have packed in. The piston moves up and down fine when you push a pencil or whatever up the end of it, but refuses to 'blow off' when it's attached to the car, even if you adjust it? Used to work fine, then i...

I've just fitted my new hybrid and there seems to be alot of hesitation, and over boost, where on the normal CT9 is pulled throughout the rev range and bosted near perfect to 1.2 bar, where as now, there is hesitation and doesn't get going until about 5k and then jolts up again closer to 7k...

Saw you at the track and drift day at RAF barkston heath. Wasn't expecting a starlet to turn up! You did however have a starlet Gt turbo.com vinyl down the side so maybe you're on here? Didn't get chance to chat to you because i was drifting in our Nissan s12 and you were on the track

im in the process of removing my gbox, and i'd like to know if the oil needs draining, or is it sealed? and can i get away with just pulling out the passenger side drive shaft? if so, how do you remove it?

i don't have one for this... http://uk.youtube.com/watch?v=iwyC2PW3vc8

Anyone headed to the RWYB at the pod today? ME and some peopel from the local scene are off. if and of you starleteers are about, look out for me! I'm the one with the boost = bitches sticker in the back window!

I'm stuck over what turbo to get. A hybrid CT9 or a td04. My engine wont be getting forged, but have all other supporting mods to suffice with a turbo upgrade. I thought a td04 would be best with a forged engine so you can whack the boost up and get the best out of it, where a hybrid ct9 would...

I've always wondered if the mines ecu is really as good as, or better than a well tuned emanage ultimate. They cost roughly the same price, but what is really the better Ecu? Would it be best to get rid of my mines unit and get an ultimate?? Obviously the mines is plug and play. No hassle, no...

I seem to have a problem with leaking gaskets all the time, and my dad puts it down to the poor design from toyota with how the manifold bolts to the block. He says it needs to be bolted again in the bottom middle for a proper fit. He insists it could be done. Tap a thread into the block. Is...