Search results

Hi all, Does anyone one know if the turbo seals failing on an ep82 would cause increased crankcase pressure? cheers

Hi Everyone, Looking for a set of oem rear brake calipers for an EP82. Must be in good working condition (i.e not seized). Thanks

Hi all, Just wondered if chatter would be effected by the location of the dump valve on a FMIC i.e hot pipe side or close to throttle body?

Hi all, recently noticed blue smoke from my ep82. It doesn't smoke on start up and it doesn't smoke at idle which probably rules out valve stem. if I keep it on boost there is no smoke either but when I let of the accelerator and the revs drop to around 2000rpm there's a bellow of...

think I have got an electrical fault. Just warmed the car up and it ticks over at 750rpm, when I switch the lights on the revs go up as normal but when I switch the heater on the car idles at about 400rpm. should the revs go up with the heater blower on? alternator squeaks under load. if I...

Hi all, Does any one know where the earth is behind the dash on an EP82 and is there an easy way to check this? thanks

Hi All, Having a problem at the moment with low idling. the other day I noticed that when I switch the heater on the revs don't go up, is this correct? the revs go up when I switch the lights on but when I put the heater on aswell the revs drop and nearly stalls the car. I have removed the...

Thanks for the response mate. That's what I was thinking but I've never had it happen before. I guess them stupid power flex engine mounts won't help then?

Hi All, Had a problem the other day where my ep82 cut out and wouldn't start again. I opened the bonnet and the plug lead for number 2 cylinder was half way out so I thought this was the problem. I pushed it firmly back in and it wouldn't start. There was a very weak spark at the king lead...

need advice on this please.

is there any differences between the 2 10040's. fuelcut?

why is there a question mark next to the 1st ecu on your list?

mines doing this. I'm think it could be cylinder related as I've checked everything else.

I will replace the PCV valve and see how I go. I've done a few checks and at tick over there is air coming out of the breather and under the oil cap. When revved this stops. I think this is correct, can anyone confirm?

Would the PCV valve not functioning correctly cause oil to come out of the breather? Is there anything else that could cause it?

Hi All, I fitted a filter to my cam cover breather 6 months ago and have noticed that it has some oil in it. are you supposed to replace these frequently?. also used about 500ml of oil in the same period of time. how much oil does yours use? plugs are fine and the car runs sweet. no smoke at...

Hi All, Just a bit unsure about what heat range spark plugs to use in my Mk1 EP82? Running about 0.8 bar of boost with SPS Mani, decat, FMIC, relocated air filter, HKS actuator and normal CT9 turbo with ported wategate. Surely heat range 6 is ok? don't think heat range 7 is needed. can anyone...

Hi All, Is there a way to adjust the beam height on a set of quad lights? (EP82) Thanks

Solved. TPS sensor needed adjusting. Once the TPS was adjusted the ECU didn't show any faults. Ticks over at 750rpm when warm as the previous engine did. Thanks for all responses and Wee john for his tutorial on TPS. Now It's time to boost.

Problem solved. It was the throttle positioning switch. Once I set the TPS correctly the ECU didn't show any faults.