benGT
Member +
Hutch, to initialise the SAFC you select it from the menu then select 'yes'. You then have to switch off the ignition and back on again.
Then you have to go through and set the sensor type and throttle type (it's all in the instructions). Only then should you switch on the engine.
On another note, the reason you werent having any problems with the FCD before was because it was wired into the Oxygen sensor wire and not the Pressure Intake Manifold wire......basically it wouldnt have been doing anything.
Also, to clear the ECU error codes remove the EFI fuse for 30 seconds (or disconnect the battery)
Then you have to go through and set the sensor type and throttle type (it's all in the instructions). Only then should you switch on the engine.
On another note, the reason you werent having any problems with the FCD before was because it was wired into the Oxygen sensor wire and not the Pressure Intake Manifold wire......basically it wouldnt have been doing anything.
Also, to clear the ECU error codes remove the EFI fuse for 30 seconds (or disconnect the battery)