how to wire an emanage ultimate for an ep82

[williamocarroll1982]

hey sparky did you ever get ur emu running via the info hosted here ??

reason i asked is cause i have a few concerns as im now trying to put my EMU in my ep82

first of all acording to the document on here the brown emu wire(RPM) should be tapped to connect 1 pin 7 on the ecu
now looking at the ecu pin out it says that pin 7 on connector 1 is ignition feed back from coil
how ever pin 21 on connecter 1 is labled RPM
so is the document correct or should this be changed ???

secound the document indicated that the analog out put wire for the emu is light blue brown . looking at my emu harness there is no such wire combo nor is this combo listed in the emu manual

analog imput is also as per the document yellow grey how ever according the emu manual that color combo is for the injector output signal ch3

there for analog input should be white green

and anlog output should be green grey

correct me if im wrong guys dont wana damage my emu or my ecu thanks

also could some one please conferm if this input and out put got to the fuel cut wire (pin 4 connector 2) or boost controller wire (pin 15 connetor 2)
the document idicates that the auther was not sure

third the emu grey white (crank angle signal input )accourding to the document goes to connector 1 pin 21 (intergrated ignition assembly (rpm)) yet pin 9 on connector 1 is labled distributer crank angle



could some of you guys who have done it right befor please help

thanks

You are indeed correct, its seems that I may have made a mistake with the analogue input/out wires. My apologies. I will get the mods to remove the file and I will make the necessary changes to it. Again, my apologies for the mistake

 

[chinesemafia]

no biggy

still need help with thisa section

could some one please conferm if this input and out put got to the fuel cut wire (pin 4 connector 2) or boost controller wire (pin 15 connetor 2)

 

[chinesemafia]

any help guys ????????

 

[williamocarroll1982]

any help guys ????????

I will be correcting my mistakes over xmas holidays. I need to get my hands on an emu loom at my mates garage in order to check the wire colours as not all of the are identified in the manual. When I have this done, I will post it back up.

 

[mad 4 tar tobin]

I know this is years old but is there any better up to date diagrams around my ep82 won't start wit emu plugged in need info asap

 

[HYBRID]

how did u wire it up? also did you set the correct parameters and jumpers before trying to start her up?

kon

 

[mad 4 tar tobin]

I tryed pm u there but ur pms are full HYBRID what's ur name on Facebook I can send u pic of diagram I used. How do I change parameters and jumper mate

 

[mad 4 tar tobin]

From a member on hear got a diagram. No I never touched parameters or jumpers not to sure about them mate