williamocarroll1982
Member +
hey sparky did you ever get ur emu running via the info hosted here ??
reason i asked is cause i have a few concerns as im now trying to put my EMU in my ep82
first of all acording to the document on here the brown emu wire(RPM) should be tapped to connect 1 pin 7 on the ecu
now looking at the ecu pin out it says that pin 7 on connector 1 is ignition feed back from coil
how ever pin 21 on connecter 1 is labled RPM
so is the document correct or should this be changed ???
secound the document indicated that the analog out put wire for the emu is light blue brown . looking at my emu harness there is no such wire combo nor is this combo listed in the emu manual
analog imput is also as per the document yellow grey how ever according the emu manual that color combo is for the injector output signal ch3
there for analog input should be white green
and anlog output should be green grey
correct me if im wrong guys dont wana damage my emu or my ecu thanks
also could some one please conferm if this input and out put got to the fuel cut wire (pin 4 connector 2) or boost controller wire (pin 15 connetor 2)
the document idicates that the auther was not sure
third the emu grey white (crank angle signal input )accourding to the document goes to connector 1 pin 21 (intergrated ignition assembly (rpm)) yet pin 9 on connector 1 is labled distributer crank angle
could some of you guys who have done it right befor please help
thanks
You are indeed correct, its seems that I may have made a mistake with the analogue input/out wires. My apologies. I will get the mods to remove the file and I will make the necessary changes to it. Again, my apologies for the mistake