Search results

Hi Guys and Girls, myself and a few friends are looking to setting up a track day at knockhill on the above date. It will be a 4hour open pit session from 2pm till 6pm the price for hiring the track is £4800. We are looking to get a minimum of 30cars here is how it brakes down...

As above, needing one, getting sick of opening my bonnet with a long screwdriver lol

Hey guys, just wondering if r888's all round are safe to run on track without a baffled sump? ive heard stories (on other cars) of people running r888's, giving too much grip, all the oil in the sump to move to one side, causing oil starvation for the oil pick up.

Hey guys been down at performance hq today to get the car mapped, I have to say Russ is a top bloke would defo recomend to anyone, anyways the car made 283 bhp at the wheels, The car went great untill i started to have a problem with the crank sensor so went back to see Russ, he had a quick look...

Does anyone know what colour of wire is used for the rev counter (the one that plugs into the back of the dials) on a 96 glanza? had a search but couldnt find anything for the glanza, found out the colour for the gt turbo but thats no use lol

Hey guys, fitted a DTA ecu today, its all up and runing but when i turn the car off and start it again i have to wait till the fuel pump primes before i can start it, would this just be down to needing a map? the ecu has a map on it but not for my setup. Also does anyone have an interior loom...

as above anyone got one?

Done a Diagnostic check today and got code 12 (rpm signal) and 42 (vehicle speed sensor signal) im putting code 42 down to my snapped speedo cable, what sort of things can cause code 12?

Anyone using one? i was thinking about getting one, wasnt sure if they would cause problems keeping the heat in the turbo? also if they are a waste of money?

Just off the phone the sky insurance, got an awesome quote for the glanza and civic, when ur renewal comes through give these guys a shout. thanks again sky :D

as above, anyone got one for sale?

Anyone run cruise valve springs? ive got a set fitted, my head seems a bit chappy, just wondering if its a bit more chappy because the springs are stiffer than standard?

Anyone fitted powerflex rear axle poly bushes? I tryed fitted them but they seem too big?

as above, anyone got a good condition one?

Anyone know what size thread is on the turbo oil feed bolt that goes into the oil filter housing?

Hey Guys, I bought a ball bearing turbo of ebay, it was ment to have covered under 500km and in perfect working order, i received it yesterday and has mega shaft play, the blades on the inlet side hit the housing and theres a crack in the wastegate. The seller says the shaft must off got...

Anyone know what size arp conrod bolts fit scat conrods? Edit, just had alook and they use arp 2000 3/8 unf x 1.6. i have a set in my garage but they dont fit, so it brings me back to this thread...

As above, i was told they were Scat conrods but my new block didnt need notched (I always thought the block needed notched when using these conrods?) My old engine was built by Toytuning, it was ment to have wiseco pistons and scat conrods, when i stripped it down i found out it had Ross...

Hi im just checking my piston ring gaps, i was wondering what specs people used? the spec sheet says, high performance street and strip .0045 for the top ring and .0055 for the 2nd ring street moderate turbo and nitrous .0050 for the top ring and .0055 for the 2nd ring im not too sure...

as above or are you just aswell getting new ones?