Search results

Hey guys Im interested to see if anyone has a block with piston and crank assembled.

Hi guys I have a 1992 4efte EP-82 that is stock at the moment. I did a top end rebuild on it about a year ago. (Cleaned head, new valve stem seals, new head gasket, oil pump, rear main seal) Since I put the engine back together I have installed a Wideband (After market Lambda Sensor) gauge...

Hey guys I have a 1992 4E-FTE (EP-82) with stock internals. IM running 8 psi of boost and so far aside from a a valve cover gasket leak its been great. So i noticed a whining noise when the turbo spools up past 2500 rpm. I have seen similar problems to mine on TGTT but the difference was that...

Hey guys I have a 1992 4E-FTE(ep-82) motor and i was wondering if the knock sensor from a US spec Toyota Paseo or JDM spec Sera. Cheers Cristian

Hey guys I live in the States and I was wondering if anyone on this forum knew where to buy a brand new Idle Air Control Valve. I took mine out and cleaned it but it showed little or no improvement. What I mean is if I unplug the IAC there is no change to how the engine run. So there for I...

Hey Guys is there a DIY guide with pics on how to properly shim a Oil Pressure Relief Valve. From what i read on here some of the guys have down it and have been able to raise their oil pressure up. I would like to do the same. Thanks Cristian

Hey guys i have recently bought a 5E-FE head to go on a 4e-fte block. The reason behind that is that no one in the US has a 4e-fte head for sale by its self. None the less I was wondering if a stock 5e-fe head gasket will fit on a 4e-fte block? Cheers Cristian

Hey guys i have the link here as well let me know it this would work. cheers Cristian

Hey guys Does anyone know the part number for a stock oxygen sensor on a 92 4efte EP-82? Thanks Cristian

good day I am looking for a picture that shows correctly how all of the sensors are connected on the thermostat housing. Either a direct pic or a link to a different website would be very helpful.

Hey guys, I noticed when i went to change my oil on my 4efte ep-82 starlet engine that there was a pretty strong smell like petrol. The oil its self has only been in the car for about 200 miles and its all thinned out and black(its SAE 20w-50 regular). I read online that it could be one of a...

Hey guys i finally got my oil pressure issue figured out but now i have a boost issue. I am running a sotck setup on a 92 4e-fte motor. Currently i am running it at 6 psi. Normally the car should be a little more responsive but when i floor it bogs down a little bit and does not accelerate very...

hey guys I know by now everyone must be really annoyed by my posts in regards to the oil oressure issue. But I hope one more wont hurt. So as I said before I was able to get oil pressure by priming the pump using a electric drill. Today I drove the car for a few miles under light boost load...

Hey guys i posted a thread a few backs in regards to having no oil pressur ein my ep-82 starlet motor. Well after reading alot in regards to this problem on this forum especially i can safely say that i think my oil pressure relief valve is stuck open. 1. I changed my oil pump but still no...

Hey guys i have a biggggg problem. It seems that i have no oil pressure flowwing throught my 4efte ep-82 engine. I replaced my oil pump thinking that was the culprit. However when i started the car up again the second time i again noticed no oil pressure what so ever. Do i need to replace the...

Hey guys After me and my buddy were able to set the timing right on the 4e motor we cranked it up and it turned over fine. The car ran for about 30 seconds or so then pretty much the engine stoped BRUTTALY. It almost sounds like it ceased up or somehting i wasnt able to turn the crank or the...

Hey guys I need a new timing belt tensioner spring for my 4efte motor. Unfortunately it seems that no one in the State of Georgia sells it. DO you know of a website that sells it or would i have to call Toyota UK to try to order it? Thanks Cristian

Hey guys I have just recently completed a top end rebuild(head gasket, new seals, valve springs, etc) on my 4efte ep 82 starlet motor. Yesterday i was able to start the engine with no problem at all. It ran fine for about 5 minutes. Then it mysteriously shut off by its self. I tried starting...

hey guys I need to buy some valve seals for my starlet motor only thing is that I need to order them from the UK. So i was wondering if a 1992 Toyota Sera has the same valve seals. Because i can buy Sera seals at a local parts store. Any help would be greatly appreciated Cristian

HI I just recently took apart my EP-82 4E-FTE engine and i am waiting on some replacement parts to come in. It has been a while since i have taken the engine apart and I fear that i may have forgotten how everything goes back together. Currently the block is sitting on an engine stand by its...