Search results

recently i had noticed the engine temperature has been dropping down.when i leave it idleling it goes up to the normal position,just roughly above half.when i drive it,it drops down to cold and the same when i turn the heating on.would the temerature sensor or the thermostat be gone?thanks guys

has anyone fitted them recently 23/30 and had any problems with their abs?have to order 2 and dave hasnt got any in stock

has anyone had one go on them before?should there be much play in them?

has anyone had to replace the bearings on the driveshaft ?the bearings that go into the green cv cup?just had a terrible constant noise when i drive above 50kmh +

i was driving home earlier on the motorway and i eased off at 100kmh and all i could hear was a loud thumping noise.it was constant the whole way home.its noy noticeable at low speed once i go over 60kmh and i come off the accelerator it happens.was told its most likely the bearings on the drive...

im still getting the codes 31 and 32 from the check and i have taken out both sensors loads of times and and there are no metal bits stuck to them.i have tried clearing the codes but they are still showing.took out the EFI fuse aswell.its really starting to annoy me now:mad:has anyone else been...

as above,i told it was from a gt advance.it has two housings on it but where the speedo cable on my glanza gearbox is,this have a pin type connector?[/IMG][/IMG]

i changed the gearbox after the last gearbox seized and now the starter motor isnt fully lining up with the bolt holes.would this mean that the flywheel is after bending??

are they hard to get off?i got a replacement gearbox but it hasnt got them on it

is there any way of noticing a gearbox from a 1.3 starlet to a 1.3 tubo starlet?

anyone got a manual gearbox for a glanza ep91?

i replaced my clutch today with the help of my dad and when i started the car up it sounded very rattley but when i push the clutch peddle it still makes the noise till i move the gearstick towards a gear and its very hard trying to get it into any gear.has anyone had this problem before?

i tried to put on a blame flame exhaust system today and i couldnt get the back box to hang properly,it seems very far off the bumper cut out.has anyone got pics of their back box sitting on the rear support on a glanza??

anyone installed this system before?i just got one today

as above,looking for an aftermarket system in good nick.ideally located close to dublin

would these fit a glanza?there 15 inch and 5x114.cheers guys

i was just wondering would the water lines from a glanza be the same length as ones for a gt?my bro has a gt and i know of a glanza thats getting broke so i just need to know would they be identical?thanks

i disconnected both abs sensors from beside the wheels on the drivers front and the passengers front.needless to say,both senors were covered in metal filings!!!:mad:cleaned them with a wire brush gently and connected them back up.still the abs light was on so i put the jumper in between Tc and...

well i got the 2 cv joints replaced by a local mechanic and the abs light has been on constantly.i was wondering if there is a handy way to check if there is a abs ring on the joint.just thinking he might have got non abs cv joints

as above:)do i have to bridge out terminals in the fuses?