they are thinner than 5efhe rods but if you use a 1.2mm metal gasket or even 1.4 you will still be fine
but i dunno if i have them still ill have to look
thats what i like to hear dude! get stuck in and get it done im sure after the hard work the results will be worth it and make you forget any of this even happened
we are here for abit of motivation to get the job done! maybe document the hole thing make something out of it?
http://www.toyotagtturbo.com/forums/showthread.php?74181-5e-Torque-Settings
take a look at this pal ^^^ - and i have found my 5e rods and pistons too if you need them
I've seen that thanks for that! It looks like they are only the efe rods not the efhe rods...
I've just got the engine out. Will be a process to get it stripped down to find the full extent of the cock up.
The caps on the rods were only torqued to 15nm. Not 29
was ther a side view ?