Search results

Hi all, Does anyone one know if the turbo seals failing on an ep82 would cause increased crankcase pressure? cheers

Hi Everyone, Looking for a set of oem rear brake calipers for an EP82. Must be in good working condition (i.e not seized). Thanks

Hi all, Just wondered if chatter would be effected by the location of the dump valve on a FMIC i.e hot pipe side or close to throttle body?

Hi all, recently noticed blue smoke from my ep82. It doesn't smoke on start up and it doesn't smoke at idle which probably rules out valve stem. if I keep it on boost there is no smoke either but when I let of the accelerator and the revs drop to around 2000rpm there's a bellow of...

Hi all, Does any one know where the earth is behind the dash on an EP82 and is there an easy way to check this? thanks

Hi All, Having a problem at the moment with low idling. the other day I noticed that when I switch the heater on the revs don't go up, is this correct? the revs go up when I switch the lights on but when I put the heater on aswell the revs drop and nearly stalls the car. I have removed the...

Hi All, Had a problem the other day where my ep82 cut out and wouldn't start again. I opened the bonnet and the plug lead for number 2 cylinder was half way out so I thought this was the problem. I pushed it firmly back in and it wouldn't start. There was a very weak spark at the king lead...

Hi All, I fitted a filter to my cam cover breather 6 months ago and have noticed that it has some oil in it. are you supposed to replace these frequently?. also used about 500ml of oil in the same period of time. how much oil does yours use? plugs are fine and the car runs sweet. no smoke at...

Hi All, Just a bit unsure about what heat range spark plugs to use in my Mk1 EP82? Running about 0.8 bar of boost with SPS Mani, decat, FMIC, relocated air filter, HKS actuator and normal CT9 turbo with ported wategate. Surely heat range 6 is ok? don't think heat range 7 is needed. can anyone...

Hi All, Is there a way to adjust the beam height on a set of quad lights? (EP82) Thanks

Has anyone had code 51 show up before? If so, how was it cured. Thanks Neil

Hi, Just fitted a new engine into my ep82 and I've noticed the idle is at about 400rpm. later on after the engine was warmed up the idle went lower than 400rpm and the oil pressure light starting flickering followed by EML. if you rev it both lights go out. Does the engine hold 3.2 litres...

Hi All, Just wondered if there is any difference between standard 4EFTE ECU's. Are the green sticker and black sticker ECU's the same? Is one for an EP91? cheers Neil

Hi all, Does anyone know where the footwell lights are located on a EP82? pictures would be helpful. cheers Neil

Hi, wondered if any one had any rear strut tops lying about for an EP82. Part number is 48750-10030 I think. Must be in good condition. thanks Neil

Hi, Does anyone know if the slam panels on the ep80 and ep82 are the same? Thanks

why do you have to bridge te1 and e1 ports on diagnostic plug to set the timing?? i didn't, should i do an ecu reset?

hi all, got a major problem. my header was blowing water out,checked head gasket and it had blown. replaced it and built back up and now there is no power. the stock boost gauge still goes up fine but seems like the timing is retarded. everything thing was marked up in regards the timing side...

hi all, just wondered if anyone knew if the distributor drive is offset or can it go in either way??? ep82

hi all, i'm after an oil feed return pipe hose. its the elbow that goes to the sump. as far as i know they only sell them as part of a kit. don't really want to buy the kit. any ideas would be helpful apart from going to toyota for one because i need it sharpish.