Search results

what do you guys use when puttin in a straight pipe,is there anyone on here with 3inch piping?i have on 2.5 now do u think there would b a difference?i would like to no urgantly so i could do this tmrw if anything:)

the 254 cams are relobed cams from toy tuning,this i now have in my 1500 engine,my question to you guys,do you think the standard 5e cams would give my car more grunt,or is it better to stay with the s54 cams that are in now?

finally got it to wrk hope u all like http://s626.photobucket.com/albums/tt347/crazygt1/

i no this isnt the place to post this lol but everyone checks this,am does anyyone no how i coul post pics so i can see wat u all think of my ride?i dont if u have to b a paid member or not?

hello people,question, if you were not to put a blow off valve on the piping would it hurt the car in anyway?

yo men,would anyone no what is the right way to connect up the boost guage like mine is connect up to my idle control valve lol for the a/c bbut i no that isnt right could any one please help me pics would be mos helpful

a quick question im curious,what is the reason for bigger spark plug wires?also ngk has some blue ones similar in size,would this increase voltage because they are made by ngk?also can honda leads work on our engine?

yeh men,my girlfriends car ,its a fully stock ep82 only thing is the cat is taken out,it used to read 10 psi and stay there but now it like spiks to 10psi then slowly drops off wat could cause this and wat could i do about it?

im wondering could i run standard injectors from the 4e fte to fuel my 5e at around 12 pounds with a garrett gt2554r ?and would anyon eb able to tell me wat the standard injector cc is on the 4efte?

i wanted to get an estamate on my engine,its a 5e with forged piston flat top,greddy ultimate with a nice tune,gt2554 turbo 2.5exhaust wat do think my bhp and hp would b like?

is any one familier with the the brand cp pistons i got a a set but they dont have the little resess at that top its a flat top piston would this raise compression or would it b ok it looks like the standard gt turbo piston but doesnt have the little drop in the top but it has the 2 dimples or...

i wanna go forged one time will they b way stronger than regular pistons they r the same regular 74mm is this ok and would i b able to run more boost safely and if so to how much psi?

would and of you guys no how many splines the cv joint has on the turbo starlet thanks a million

i think i found the one thicker wire and the thinner wire side by side would these be the ignition system positive wire and the ignition coil the first is a balck and red thick wire and the other is a black and white skinny one which one is which it says put a volt ohm meter on it but i dont...

could anyone tell me which one is located where or a diagram of which one is the ignition system positive and ignition coil? i am wondering this because im hooking up a d1spec vsd4some japanese thong to up the voltage going to the spark plugs

the spring rating i ither 400 infront or something and 320 in the back or the otherway around i cant remeber lolis that good

yo guys i want to put coilovers on my car how would the ride b?how about handling would it b better or worse?plz get back to me as soon as possible i would like to put them on todayy:):)i love how it looks when it is drop to the ground lol

i was driving last night and my fan went off i ran it direct it wrks,i pulled of the little switch like at the back of the engine that makes it come on but it didnt could this b the relay that is gone bad orrr i dont no can some one help me plzz

hi guys do u think a roll cage would b a nice accesary for my car ?and well i want to get it lol do u no any pics of the trd roll cage for the ep82 i would love to c what it looks like in the car!

as the topic says i wanna put those on my car ,ive seen one starlet ep82 with like a longer wing but it looks like the toms wing but extended would anyone have any pics that maybe i could show the guy what i want?