Search results

engine managent light came on my bro in laws glanza, put the reader on there and its giving me 34 ( excessive turbo charging pressure ) car runs a bar on hybrid and has done for quite some time now, would i be right in thinking to put a new map sensor in there or is there any other ideas thankyou

Good evening folks i recently won a complete engine and box on the dreaded ebay and all was great till it was delivered and turned up with a n/a gearbox ( well what i belive to be a n/a gearbox) luckily it is from a registered garage so they are willing to sort this issue but they would like me...

Can you send me your phone number gaz or if anyone has a number for him can you drop me a pm cheers

When you get chance can you look at my reply in the engine package thread and let me no ASAP cheers

Are the torque setting different between forged rods and standered rods as noticed the video on you tube by 350ep70gr torqueing down a lot more than sugested on site

I had a issue with timing on dizzy so brought a timing light put car in diagnostic mode and fine tuned dizzy. car was perfect. but noticed a slight stutter when setting off in first tonight. I have just dropped the timing light on it again and there is fluctuations in the marks lining up swaying...

Good evening all, brought a engine last week from a member and on tick over sounded sweet when we dropped it in. Took it for its first drive and the engine has a slight intermitant rattle :( I don't think its a bottom end rattle as had 2 engines with bottom end gone. Parked her to and noticed...

Please can someone send me socks number sent my misses to collect engine from him and her batt has died in wroot and she has his only number

Good mornining all, my boost controler is still set to run 0.8 and 1 bar on a td05, does anyone no what kind of fuel pressure i should be setting my sard regulator. i want to make sure its ok to drive it to raceline in halifax as its a 90 mile drive for me :(.

I am still trying to make my mind up on which clutch to use. I will be running a fully forged 4e with a td05 set up around 1.7 bar. i did look at Stage 5 Ceramic 4 Pad Sprung Clutch Kit from East coast customs but after asking dave at T-M he advised a excedy paddle. this has left me in a bit of...

http://www.gtsparkplugs.com/InjectorSizeCalc.html

Hi all, I have been gathering parts for my build over last few months or so and now im in 2 minds if it going to run safe while i can get the funds for ecu and mapping. Its the injector part that is new to me :confused: i have been round cars years and no my way around a engine in most aspects...

Good evening all i have a blitz id power meter and am getting a bit confused with it :confused: On mine it has a red,black and a white wire. I no the red is live black in negative On any info i find it says connect orange to speed out put of ecu. I dont have a...

Has anyone been bashing this last week through bulitstorm beta or will be playing these next weeks through pre order codes fancy a match drop me a pm :D :rockon:

Does anyone still have contact with Elaine Wilcox (aka Elaine ) on the site please majour rep for any info or someone that can put me in contact thankyou

Good morning all having a nightmere finding the right tyre for the starlet. I have always been a solid beliver of the T1R and dont get me wrong its not a bad choice. but just havnt got the grip i would like out of corners, then on to the eagle F1 again a good tyre but my god the side walls are...

Hi all who has experiance with traders on here and there forged engines ? looking to find out what the timescale to complete was. was it a drive in and out same day or are some traders forging your own unit any info will be great as need one dropping in but cany have car off road for any long...

wrong link :(

The road were finaly clear today after two weeks of hell, so decided to take starlet out for a drive this evening. On way home noticed a strange noise so pulled over at next lay by and just before i stoped a loud bang followed by altenator light coming on (engine still running) turned car off...

Hi all can anyone tell me what fitment the lamps are in the quad lights ? i no i can just get them from my main dealer but want to try get some better bulbs without going down the route of HID. been trying for nearly a week to find them found some that can be made to fit but would sooner buy the...