Search results

For sale: Starlet 1995 gt turbo Item Condition: used , but looked after , needs tlc on bodywork Price and price conditions:2450 ono Extra Info: Pictures: see below Contact Details: see below Location: aberystwyth , west wales Delivery & Conditions of Delivery: collection...

hi all , i have a problem with either my master cylinder or my slave . it has got to the point now where if you rest your foot on the clutch pedal it will sink to the floor with no resistance. You then have to sort of pump it a few times to get even a little bit of a bit on the clutch. i...

hi all , I finally sorted my cars emissions problems out ( it was the timing on the inlet cam that was out by 2 teeth :slap: ) ........ but now i have to deal with my blue smoke issues , only when it gets hot i start to see blue smoke in the mirror ..... now i thought it was my turbo ...

right ...... i warmed up the car and did a compression test on the car today and i got just below 130 across all for cylinders. i think that is too low , i was hopeing for a figure of about 150 ish . so should i worry about that figure being so low ? the other thing is that when im...

as some of you may know , i have come acorss a ep82 which had been standing for about a year .. after getting it back to mine ( and figuring out that it was suffering from the famous throttle body pipe issue ) i have sorted all that out and got it running properly again. but the time has...

hi all , im after a turbo for my ep82 . must be in good condition ( no smoke , holding boost etc ) let me know if you have one thanks

hi all . i am currently in work so unfortunatly i havent got the time to use the search button ..... so .... if i was to put a td04 tuerbo on to the ep82 , what exactly would i need for the job ??!!?? thanks

hi all , i am in the process of getting my starlet on the road . I have just fitted a adjustable actuator . So i was taking it up the road to test it out , and when i drove it hard it boosted to about 0.6 and then held theres for a sec or two and then shot up to 0.9 ish ..... then the car...

hi all ive done a bit of searching but i cant really find the answer to my problem. I am in the middle of changing my actuator for a adjustable one , and i noticed that when i took the standard one off , the wastegate arm that the actuator attaches too can be moved quite easily from...

hi all i have recently bought a second hand adjustable actuator to hopefully cure my boosting problems . It arrived today but it has a small hole drilled in the the side of the bottom half of it :confused: . anyone know if this will still work as normal ???

hi all , as some of you know i have come across an import ep82 . I now have a problem with the thermostat housing sensors and wires. basically , the engine water temp guage goes straight to the top ( as in when u earth the wire ) so when i disconnect the wire from one of the sensors it...

as above , any one got one thay wanna sell !!!

hi all , recently i have come across a starlet ina local garage , this garage couldnt get the car to run propery after it went in for a head gasket and timing belt change . I know the guy quite well and basically took it off him and fixed it ( it was the old water / vacum problem on the...

hi all , i am currently rebiulding a ep82 that i have come acorss , and i have that very common problem off the water and vacumm pipies on the underside of the throttle body the problem i have is that the car has had a headgasket change and it is still not right , it is still losing...

hi all , i have recently been given a 1995 starlet ep82 import . but the headgasket has gone and he is told that the head has the symtoms of a having a crack init a garage which i know has a new head off a uk 1.3 non turbo starlet. so my question is ,,,,, are they the same ??? it...