Hi,Please help and advice.I just install a second hand 2way TRD LSD mechanical type when on 1st gear from 0-20km/h the car vibrate badly as if the engine mount was bad and its ok on all gear no vibration just on pick up.I check engine mount,clutch and all seem to be ok. Before installing the LSD...
Hi, Guys I just buy the adjustable camshaft pulley from sam just want to know what the best setting for botom end power and torque. Did you put in advance or retard? Please share your views and opinion. Am running TD04L with standard camshaft.Thanks
Hi guys, Today is the worst day of my life just rebuilt my engine completely forge with new wiseco piston scat rods,arp bolts on crank,rods,and head,acl bearing and oil pressure valve has been modified.After a smooth driving of 1500 km distance I decided to map the car.When I rev hard at 7500...
Hi,please help when I am on 4th or 5th gear push accelerator hard my engine lights remains on until I switch off the acc. am thinking its fuel cut but am running only 12Psi with boost solenoid bypass.another problem all my boost lights on the clocks stays on even on idle.I check all negative...
Hi, Does anyone knows the specs of the IHI VF40.Around how much rpm it will start boosting on a 4e engine.Can it withstand 1.6bar safely and how much BHP max output.Is it bigger than the TD04L?Thanks
Hi, Something strange happening to my car it idle fine but won`t rev to 2000-3000 rpm it goes up and down its not stable but when I push hard around 5000 rpm its ok. I disconnect my TPS sensor and notice its ok. can I ran the car without tps ?Please help and advice.Thanks
Hi, am been offered uprated Titanium Valve retainer that fit 3sgte engine will it fit my 4efte head without modification. Is it direct swap.Please advice. Rep will be added.Thanks
whats the best way to make power I am running 2.5` exhaust straight with racing decat and no backbox (silencer) or other option taking out decat add a blitz nur back box? Is backbox nessary on high bhp engine. Which is the best to produce more power on drag racing 400mt run.Thanks
Hi guys I badly need help I just buy an injector adapter 2 as my car is running rich on idle but I can`t get it install. its an ep91 3plug ecu.any installation diagram will be helpful.Thanks
Hi,please help I just rebuilt my engine with brand new wiseco 74.5mm freshly rebore block and have run 1500km on low rev to keep engine smooth. I notice every 150km distance done I must add 1/2 liter of oil and engine didn`t smoke at all and no leak. I did a compression test and I got 160psi in...
Hi, am boosting my car at 1bar with supporting mode when suddenly i feel loss of power and can`t idle without throttle open at half way.I check the engine I saw lots of oil coming from the breather. Am thinking oil rings gone.Does anyone have an idea.please advice. Am going to change piston and...
Hi,Please help I have a Lsd gearbox when I active launch control on EMU the car jump to 60km/h then quickly drop to 40km/h my 2nd gear struggle to engage and I got Lag between 40Km/H to 60Km/h. I recently upgrade to paddle clutch 3pads type.When I drive normally without sudden take off its ok...
Hi, Just want to know if I can use the following parts from a 4age fit 4efte.Valve spring,camshaft,head gasket,Clutch are these parts direct swap.Thanks